Page 1
I N S T A L L A T I O N I N S T R U C T I O N S SEAT HEATER Description: Part Number: 45100-05810-FC8 Applications: AN250/400K7 Installation Time: 1.5 Hours Contents Ref. Description Seat...
6. Use care not to cause any damage to the body of the vehicle during installation of the accessory. Tighten bolts to the torque indicated Tightening Tightening Torque Diameter in the right table as standard value Torque N . m (mm) kgf-m lb-ft unless otherwise explicitly specified. 0.55 13.0 29.0 21.0 GENUINE SUZUKI ACCESSORIES...
3. Remove the trunk lamp and in- stall it to the new seat. 4. Remove the front leg shield Window Screen cover, the front leg shield, win- dow screen and meter front panel. Meter Front Panel Front Front Sheild Sheild Cover GENUINE SUZUKI ACCESSORIES...
Page 4
8. Pass the subwire as shown in the Subwire right figure. WARNING • Position the wires carefully not to prevent driving. • Be careful not to caught the subwire by the front fork when steering the handlebar. GENUINE SUZUKI ACCESSORIES...
Page 5
12. Install the seat and mount the connector of trunk lamp and seat heater. 13. Set the main switch ON and de- press the seat heater switch. And be sure that the front seat be- comes warm. Paper pattern for Install the Switch GENUINE SUZUKI ACCESSORIES...
Page 6
• Do not try to remodel it. It may catch fire causing a big fire. • When any anomaly occurs, contact with SUZUKI Dealer and ask for a detailed inspection. • Do not operate the switch during running.