HOW TO REMOVE/ATTACH PARTS
Caution
● Before removing parts, take out all the foods on the parts.
● Do not remove parts except the ones listed here.
Please contact with a Hitachi customer service centre for cleaning such parts after removing them.
Draw the shelf, and pull off the 2 pins on the
lower right and remove it.
R-SF48EM type
How to remove
Pull out the Vacuum Case by slightly lifting up
and moving up and down.
60
BB0040171S_R-SF57_48_45EMseries_B.indd 60
Fixed shelf
R-SF57EM type, R-SF45EM type
Fork
Fork
Height adjustable upper and middle shelf
Slightly lift up the back
of the shelf and draw it.
Forks of the
shelf
When installing the shelf, slide it until it reaches to the interior wall, then
slightly lift up the back of the shelf and push it in.
(hitch the forks of the shelf to the parts on the back of the shelf)
Caution
Door may damage if drawing the shelf without turning it.
Be careful to attach/remove the glass shelf because it is heavy.
If it drops, it may break and cause bruise or injury.
Glass shelf: R-SF57EM type
Plastic shelf: R-SF48EM type, R-SF45EM type
Door pocket
Lift up the door pocket while
tapping the left/right of its
bottom surface, and remove it.
(It is fixed a little tightly.)
Insert the door pocket fully to the end when installing it.
Caution
If it drops, it may break and cause bruise or injury.
Height adjustable lower shelf
Slightly lift up and pull out.
R-SF48EM type
Caution
If you pull out the shelf straight, it may hit the
door.
Vacuum Case
How to attach
Insert the Vacuum Case so that both right and left
convex ribs on the case can slide under the guide
rail of the Vacuum Container.
Lastly, hold down the handle to lock.
Vacuum Container
Convex rib
Vacuum Case
Raise the shelf as shown in
figure, and turn it and remove it.
Tap
Tap
R-SF57EM type, R-SF45EM type
Request
Guide rail
Check that it is fixed properly
by taking it in and out a few
times.
15.6.1 4:01:10 PM