Simpson SSM6100WB User Manual page 5

5. If the refrigerator now rocks from one corner to the opposite
rear corner, this means that the floor is uneven; you will need to
put some packing under one of the rear rollers. You could use
thin pieces of solid material, such as thin board, vinyl floor tiles or
laminate. Place the packing so that it will sit under one of the rear
rollers when the refrigerator is rolled into position.
6. You may now need to fine-tune the installation by repeating
Steps 3, 4 and 5.
7. When you have the appliance in its final position, it needs to be
stabilised. Wind the stability foot down to the floor until it just
makes contact with the floor. Lift the front of the appliance to
take the weight off the stability foot, then turn it ¼ turn further
to ensure firm contact with the floor. Whenever you need to
move the appliance, be sure to wind the foot back up so that the
appliance can roll freely and be sure to reset it when reinstalling.
Whenever you need to move the refrigerator, be sure to wind the
foot back up so that the refrigerator can roll freely.
side view
Stabilising
foot wound
down
8. Clean your refrigerator thoroughly following the instructions
on page 11 and wipe off any dust that has accumulated
during shipping.
9. Plug the refrigerator into the power point. Don't use a double
adaptor. If you need to roll the refrigerator out to get at the
power point, remember to raise the stability foot before you
do so.
10. We recommend that you let your refrigerator run for two
to three hours before you put any food in it. This will allow
you to check that it is operating properly.
Congratulations! You have successfully installed your
new refrigerator.
Keep ventilation openings, in the appliance enclosure
or in the built-in structure clear of obstruction.
front view
¼ turn
Adjusting door alignment – Side by Side refrigerator only
Each door is independently adjustable in the vertical direction by
turning the adjustable bolts under the hinges using a spanner.
The doors can be adjusted up or down. Depending on
the amount of adjustment required it may be sufficient
to adjust only one door. (see Diagrams below)
Large plastic roller nut
Note: When the height of the rollers and adjusting bolts are correctly adjusted the
refrigerator will stand firmly on the floor then adjust door alignment as required.
Simpson Refrigeration installing your refrigerator 5
Adjusting Bolt
Front Roller