Table of Contents
Advertisement
Time programming function
This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■
A hotplate should switch off automatically
The hotplate switches off automatically after the time that is set
has elapsed.
Setting procedure
The hob must be switched on.
Select the hotplate and the required heat setting.
1.
Touch the
0
symbol.
x
2.
hotplate.
‹‹
appears in the timer display.
Within the next 10 seconds, select the required cooking time
3.
on the settings range.
The cooking time begins to elapse.
Notes
The same cooking time can be set automatically for all
■
hotplates. The set time for each of the hotplates counts down
independently.
The Basic settings section contains information on
automatically programming the cooking time.
If the combi zone or move function is selected when the
■
hotplates are combined, the set time is the same for both
hotplates.
Cleaning lock function
Cleaning the control panel while the hob is switched on may
change the settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
>
symbol. A signal sounds. The control panel is
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator
œ
/
•
flash alternately in the display.
lights up in the display for the
"
,
‰
symbol and the residual
Changing or cancelling the time
Select the hotplate and then press the
Change the cooking time using the programming zone or set
to
in order to cancel the time.
‹‹
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The time
program function lights up
When the
symbol is pressed, the indications turn off and the
0
beeping stops.
Notes
To program a cooking time of less than 10 minutes, always
■
press 0 before selecting the desired value.
If cooking times have been programmed for various zones,
■
the time program function always displays the time of the
selected hotplate.
Cooking times can be programmed for up to 99 minutes.
■
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
Press the
0
symbol until the
1.
up in the time program function display.
Adjust the desired time in the programming zone.
2.
The time starts to count down again after a few seconds.
Changing or cancelling the time
Press the
symbol and the
0
Change the cooking time in the programming zone or press 0
to cancel the time.
Once the time has elapsed
Once the time has elapsed, a beep will sound.
displayed in the time program function display. After pressing
the
symbol, the indications turn off.
0
locked for 35 seconds. The control panel surface can now be
cleaned without the risk of changing the settings.
Note: The lock does not affect the main switch. The hob may
be turned off when desired.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
symbol.
0
for 10 seconds in the display.
‹‹
U
indicator lights up.
indicator lights up.
U
and
‹‹
‹‹
lights
are
U
11
Advertisement
Table of Contents
