Installations/Connections - Panasonic WV-NP244 Operating Instructions Manual

Installations/Connections

Before start the installation/connection, prepare the required devices and cables.
Before starting the connection, turn the power of the devices including the camera and the PC
off or disconnect the AC adapters from the outlet.
Step 1
Fix an optional camera mount base onto the
desired place and mount the camera on it.
When attaching an optional camera mount
base on the bottom of the camera, use the
removed screws to attach the camera mount
base.
Otherwise, it may cause a drop or malfunc-
tion.
<Example>
Tripod mount base
Important:
Method of installation may be different
depending on the material of the place
where the camera is to be installed.
Step 2
Connect the monaural mini plug (ø3.5 mm) to
the monitor out connector (for adjustment) on
the rear of the camera. (Only when adjusting
the angular field of view)
14
Fixing screw
Connect to the video
monitor, etc.
Important:
The monitor out connector is provided
only for checking the adjustment the
angular field of view on the video monitor
when installing the camera or when serv-
icing.
It is not provided for recording/monitor-
ing use.
Step 3
Connect the power cable.
• When using AC 24 V/DC 12 V power
supply
SD
EXT I/O
CARD
1 2 3 4
POWER
GND
AC 24V IN : 1L – 2N
DC 12V IN : ! – @
GND wire
• When using PoE (Power over Ethernet:
IEEE802.3af compliant)
Connect a LAN cable (category 5 or bet-
ter) between a PoE device (such as a
PoE hub) and the network connector of
the camera.
10BASE-T/
MONITOR OUT
LINK 100BASE-TX ACT
INITIAL SET
SD
EXT I/O
CARD
1 2 3 4
POWER
GND
AC 24V IN : 1L – 2N
DC 12V IN : ! – @
– +
AC24 V
DC12 V