Table of Contents
Advertisement
Howto Use the Hold/Timer
Your t-10 LD/TIMER, which oper-
are timing a three minute phone
tions. The time can range from one
~d
ates without
microwave energy,
call, touch 3, 0, and O.The display
second to 99 minutes and 99 sec-
has three timing functions,
shows 3:00.
ends. A HOLD, or "standing" time
It operates as a Minute Timer, it
Step 3: Touch START. The readout
may be found in some of your own
can be set to delay cooking or may
display shows the time as it counts
recipes or Cookbook.
be used as a hold setting after
down.
To set the oven to delay cooking
defrosting. Hold/Timer can be set
Step & When time is up, a signal
up to 99 minutes follow Steps 1
up to 99 minutes and 99 seconds.
sounds and the timer turns off,
and 2 to enter hold time, then set
Step 1: Touch HOLD/TIMER pad.
Time Cook and time, or Temp
The display shows :0. Signal light
Cook and
temperature desired
above HOLD/TIMER flashes.
before
pressing
START. When
holding
before
temperature
Step 2: Select the amount of time
The HOLD/TIMER
can also be
cooking, be sure probe is in food
you desire. Touch the appropriate
used to program "standing time"
before pressing START.
number pads. If, for example, you
between microwave cooking func-
How
to
Defrost–Hold/Time-Time cook
To help you become acquainted with the HOLD/TIMER feature as used with Time Cook or Temp Cook follow
Steps below to defrost a frozen casserole for 15 minutes, then hold 10 minutes and then cook 25 minutes. if using
Temp Cook after Hold/Timer, be sure to insert probe correctly as shown in Temp Cook section of this book. after
HOLD time.
Step 1: Remove casserole from the
freezer and place in oven. Touch
the DEFROST pad. The readout
panel shows :0 and signal light
above DEF. flashes.
Step 3: Set standing or hold time
by touching HOLD/TIMER. :0 ap-
pears on display. Signal light above
HOLD/TIMER flashes.
Step 2: Touch 1, 5, 0 and O for
defrosting time. 15:00 appears on
display panel. (Defrosting is auto-
matically set on Power Level 3 but
can be changed
by touching
POWER LEVEL pad and the new
Power Level.)
Step 4: Touch 1, 0, 0 and O to hold
for ten minutes, 10:00 appears on
Ai--l m.,
I
a
Step 5: Touch the TIME COOK
pad. This display shows :0 and
@
signal light above TIME COOK
flashes.
Step 6: Touch 2, 5, 0 and O for
twenty-five
minutes
of cooking
time. 25:00 appears on display.
Step 7: Touch START. 15:00 count-
ing down shows on display. As
each function is automatically per-
formed oven display shows entered
information
and light above that
function comes on. While cooking,
you may touch appropriate pad to
ulaptay.
retail times you set.
Questions
and
Answers
' Q. What will happen if I acciden-
tally reverse the instructions?
A. If you accidentally reverse the
sequence of programming instruc-
tions,
your oven automatically
rearranges your program. Defrost-
ing always comes first, then hold,
and then the cooking function.
Q. I programmed my oven for a
specific defrosting time but it de-
frosted
longer than necessary.
What happened?
A. When instructions conflict, the
oven carries out the last instruc-
tion. You may have set the oven to
Defrost for 4 minutes, Hold/Time
for 2 minutes, and then Defrost for
6 minutes. In this case, the oven
would Defrost for 6 minutes and
Hold/Time for 2 minutes.
Q. Can I Defrost-Hold only on my
oven?
A. Yes, for foods you don't want
to cook, like frozen fruit, frozen
whipped
topping,
etc.—refer
to
Cookbook.
NOTE: Allow foods to remain at
room temperature only as long as
safe. Times will vary.
Advertisement
Table of Contents
