Power Source; Remote Control - Sharp GX-BT3 Operation Manual

Power Source

Wall socket
AC 100 - 240 V ~
50/60 Hz
„ AC power connection
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
„ Bluetooth standby mode
 The first time the unit is plugged in, the unit will enter
the Bluetooth standby mode. Pairing indicator will light
up.

Remote control

„ Battery installation
1
While pushing the locking tab towards the centre of
the remote control, slide out the battery holder.
2
Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Battery holder
Battery type
Locking tab
Precautions for battery use:
Remove the battery if the unit will not be used for a long
period of time.
This will prevent potential damage due to battery leakage.
Caution:
 Do not use rechargeable battery (nickel-cadmium bat-
tery, etc.).
 Danger of explosion if battery is incorrectly replaced.
 Replace only with the same or equivalent type.
 Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
 Installing the battery incorrectly may cause the unit to
malfunction.
Downloaded From Disc-Player.com Sharp Manuals
Back of remote
control
Locking tab
Positive (+)
side up
Polarity (+)
symbol
 To cancel the Bluetooth standby mode, press the ECO
MODE button (remote control) during Bluetooth stand-
by mode. The unit will enter the low power consump-
tion mode.
 To return to the Bluetooth standby mode, turn the unit
on and off again.
 During Bluetooth standby mode, the unit will turn on if
Bluetooth connection is established.
Notes concerning use:
 Replace the battery if the operating distance is reduced
or if the operation becomes erratic. Purchase "CR
2025", coin lithium battery.
 Periodically clean the transmitter on the remote control
with a soft cloth.
 Exposing the sensor on the unit to strong light may in-
terfere with operation. Change the lighting or the direc-
tion of the unit if this occurs.
 Keep the remote control away from moisture, heat,
shock, and vibrations.
„ Test of the remote control
The remote control can be used within the range shown
below:
Remote sensor
0.2 m - 6 m
(8" - 20' )
E-4
ECO MODE
ON/
MUTE ECO MODE STAND-BY
BASS TREBLE VOL
X-BASS
PAIRING
BLUETOOTH AUDIO IN USB
DIMMER
RRMCGA342AWSA
ON/
MUTE ECO MODE STAND-BY
BASS TREBLE VOL
PAIRING X-BASS
BLUETOOTH AUDIO IN
DIMMER