Put In Detergent; Maintaing The Washer - LG WD-8030W Owner's Manual

Put in detergent

Adding detergent and fabirc softener
• Pull out the detergent drawer.
• Put the detergent and fabric softener in the detergent drawer before washing.
• Close the detergent drawer completely.
The drawer for fabric softener
• Do not leave the fabric softener in the detergent drawer for
more than 2 days. (Fabric softener could harden)
• Do not open the detergent drawer during water fill cycle.
• Softener will automatically add during last rinsing cycle.
• Do not fill past MAX indicator.
• Do not use solvents (trilen, benzine, etc.)
Softener level
• Programmes with PRE-WASH
Detergent for Fabirc Detergent for
softener PRE-WASH
MAIN-WASH
• MAIN-WASH only
( ) ( ) ( )
• The detergent should be used according to the instruction of the detergent manufacturer.
• If the detergent is used over the recommended amount too many bubbles will be generated thus
causing an inferior washing result. This will also cause a malfunction.
• Use front loader detergent only for drum washing machine.
Detergent dosages
Do not exceed manufacturer's recommended dosages
as shown on the detergent package.
The amounts depend on
• degree and type of soiling
• size of wash
-full-load : according to manufacturer's
instructions
-part-load : 3/4 of the normal amount
-minimum load (about 1kg) : 1/2 the amount used for
full load
• water hardness in your area.
12
P/No. 3828FR3149R( )
Choosing the right detergent
The type of detergent depends on
• the type of fabric (cotton, synthetic, delicate items, wool)
• colour
• wash temperature
• degree and type of soiling
Note : For wool only use appropriate detergents.
Maintaining the washer
Remove the power plug prior to maintaining.
Clean the filter periodically every 3 months.
Clean the filter in the inlet valve
• If no water flows through detergent drawer or filter is clogged with foreign material, PRE & MAIN LED are glittering at once.
• Remove the water from inlet hose completely before cleaning the filter.
1 2
. Turn off the water taps. . Disconnect the inlet hose
Cleaning the drain pump
• If noise occurs or water is not drained completely due to foreign material in the pump, clean the drain pump filter.
coin
2
1 2
. Open the filter cover by using coin. . Take out the drain point ( ), then the
water flows out. If the water does not flow
any more, turn the drain pump filter( ) to
the left until it is open.
To prevent being frozen in winter
1
. Turn off the water tap and remove
the inlet hose.
2
. Remove the water from the drain point ( ).
1
When the machine is frozen
1
. Remove the inlet hose by pouring 50°C
hot water around the water tap.
3
. Pour the hot water in the drawer and
maintain it for 10 minutes for melting.
3
. Remove the filter with a tool or by hand and
take out foreign material using a toothbrush.
• Insert it in original place.
2
1
1
3
. • Take out any foreign material from the
drain pump filter( ).
After cleaning, turn the drain pump
filter( ) clockwise and insert the drain
point ( ) to the original place.
• Close the Lower cover cap.
Maintenance of detergent drawer
1
. Pull out the detergent drawer.
2
. Clean it in the water.
3
. Insert it in its original place.
2
. Soak it in the 50°C hot water.
4
. Connect the inlet hose to the water tap
and check the drain after turning on the
water tap and operating the washing
machine.
13
P/No. 3828FR3149R( )