Advertisement
To supply
power to the Palmcorder and
LCD monitor:
Attach the Battery Pack or connect the DC
Power Cable to the LCD monitor.
oLJ"
Note:
Using the LGD rrJ_nitor _uduce5 battery
operating time. It is recommended to use
1.8Ah Battery Pack (PV-BP18) or 2.4Ah
Battery Pack (PV-BP17) when using the
LCD monitor.
Set the POWER switch to AUTO ON. The
LCD monitor will then turn on/off according
to the Palmcorder's
POWER switch setting.
Set the POWER switch to OFF to turn off
the LCD monitor only.
Note:
• In some instances, if you turn on the
Palmcorder's
light during operation with
the AC Adaptor, the LCD monitor may turn
off. If this should occur, turn off the light
and the LCD monitor automatically turns
back on.
• Do not directly connect (short circuit) the
positive (+) and negative (-) terminals of
the LCD monitor when Battery is attached.
Push the SLIDE RELEASE switch on the
LCD monitor.
Slide the LCD monitor to the right with
the LCD monitor folded inward as indicated
by the arrow.
Insert/remove
the cassette by opening
the door.
When storing the Palmcorder with the LCD
monitor attached, swing:
@ Flip the LCD monitor 180 degrees.
(_ Swing the LCD monitor, with the screen
facing inward, up against the
Palmcorder.
18°°
5
Advertisement
