To Disconnect Usb Cable Safely - Panasonic PV-GS16 Operating Instructions Manual

To disconnect USB cable safely

For Windows
If USB Cable is disconnected while computer is on,
error dialog may appear. In such case click [OK] and
close the dialog box. By following the steps below you
can disconnect the cable safely.
1
Double click the
• Hardware disconnect dialog appears.
2
Select [USB Mass Storage Device]
click [Stop].
3
Verify [Matshita DVC USB Device] is
selected and click [OK].
1
• You can safely disconnect the cable.
Note on the driver name
The driver name displayed will differ depending on
your OS, operating environment and the mode of the
Camcorder.
Windows XP/2000:
• When the Camcorder is in PC Mode:
[USB Mass Storage Device] or [Matshita DVC USB
Device]
Windows Me:
• When the Camcorder is in PC Mode:
[USB Disk] or [Matshita DVC]
• Some OS, such as Windows 98SE, may not show
the icon indicating that you may safely disconnect in
task tray. (OS may be set not to
Camcorder's Card Access lamp is off and disconnect
the cable. Also, with Windows Me, the icon will not
be displayed when in Tape Recording Mode or Tape
Playback Mode.
CAUTION:
If you disconnect the USB Cable while the
Card Access Lamp is on, it may damage the
Card data.
46
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
icon in task tray.
1 and
1
displayed
1
show) Make sure
With a PC
For Macintosh
Removing the USB Cable safely for
Macintosh
1
Drop the [NO_NAME] icon which appeared
when you connected the Camcorder with the
USB Cable into the recycle bin, then disconnect
the USB Cable.
If the above operation is not performed correctly, when
data is copied from the personal computer to an SD
Memory Card, the copied data may be damaged.
Even when the following operations are performed,
the same results will occur as when the USB Cable is
removed (above). Therefore, it is imperative that the
above operation
• When Camcorder power is turned OFF.
• When SD Memory Card is removed.
• When Mode Dial is turned to change modes.
1
is completed before proceeding.