Makita BTD136 Technical Information page 12

W
iring diagram
Fig. D-2
[1] Wiring of Lead Wires from LED Light Circuit
Put sponge A bundling lead wires from
LED light circuit in the place where
the extended line from rib C can cross
sponge A.
extended line
Route the Lead wires
between rib A and rib B.
Fig. D-3
[2]
Sponges Bundling Stator's Lead Wires
Put Sponge B on the Sponge A, bundling
Light circuit's Lead wires. (See Fig. D-2.)
And then, put Sponge C on the Sponge B.
(Also See Fig. D-4.)
sponge C
bundling three thick
lead wires from Stator
(blue, white, orange)
sponge A
rib B
from rib C
rib A
Fix lead wires from LED light circuit
in the three Lead wire holders because
they must be tight in this place.
rib C
Controller
Terminal
LED light circuit
Lead wire holder
sponge A
bundling lead wires from
LED light circuit
(See Fig. D-2.)
sponge B
bundling five thin lead wires
from Stator (black, red, blue,
yellow, white)
P 12/13