Load Paper In The Paper Tray - Brother MFC-9140CDN Quick Setup Manual

3
Load paper in the paper
tray
a
Pull the paper tray completely out of the
machine.
b
While pressing the green paper-guide release
lever a, slide the paper guides to fit the paper
size you are loading in the tray. Make sure the
guides are firmly in the slots.
c
Fan the stack of paper well to avoid paper jams
and misfeeds.
d
Load paper in the tray and make sure:
 The paper is below the maximum paper
mark (bbb) a. Overfilling the paper tray will
cause paper jams.
 The side to be printed on is face down.
The paper guides touch the sides of the

paper so it will feed correctly.
e
Put the paper tray firmly back in the machine.
Make sure it is completely inserted into the
machine.
4
f
Lift the support flap a to prevent paper from
sliding off the face-down output tray.
For information about recommended paper:
uu Basic User's Guide: Recommended
paper and print media.
4
Connect the power cord
and telephone line
IMPORTANT
DO NOT connect the interface cable
yet.
a
Connect the AC power cord to the machine and
then plug it into an electrical socket.
b
Press on the control panel.
IMPORTANT
DO NOT touch the Touchscreen immediately
after plugging in the power cord or turning the
machine on. Doing this may cause an error.