Before Using For The First Time; Cleaning And Care - Montgomery Ward 730862 Instruction Manual

Before Using for the First Time

CAUTION: Risk of suffocation - keep all packaging and plastic bags out of the
reach of children.
NOT DISHWASHER SAFE
1. Remove all packaging materials.
2. Clean the exterior surface of the ice cream maker by wiping it with a soft,
damp cloth. Do not use an abrasive scouring pad or steel wool as this could
damage the finish.
3. Disassemble the unit and wash according to instructions in the Cleaning &
Care section.
4. Place dry inner bowl in freezer for 8 hours prior to use. To prevent freezer
burn, put inner bowl in a plastic bag and store upright. Temperature of freezer
should be -0.4° F or colder for proper freezing of inner bowl.
Cleaning & Care
This appliance contains no user-serviceable parts. Do not try to repair it yourself.
If your appliance is damaged or does not operate, please call customer service to
repair or replace it.
PRECAUTIONS:
• Always unplug unit before assembling, disassembling or cleaning.
• Wait until inner bowl is room temperature (approximately one hour) before
removing from appliance.
• Do NOT use anything abrasive that can scratch or damage the parts or housing.
• NEVER IMMERSE THE MOTOR UNIT IN WATER
• NOT DISHWASHER SAFE
1. Clean the exterior surface of the housing by wiping it with a soft, damp cloth.
Do not use an abrasive scouring pad or steel wool as this could damage the
finish.
2. Disassemble following the instructions outlined in the Assembly section.
3. Hand wash all parts except motor unit in warm, sudsy water.
4. Dry thoroughly before assembling.
TO STORE:
Be sure all parts are clean and dry before storing. Store appliance in its box or in
a clean, dry place free from sharp objects. Inner bowl can be stored in freezer so
that it is ready to use when desired. Freeze for at least 8 hours prior to use.
6 Wards.com
Assembly
Disassembly
CAUTION: Unplug unit before disassembling.
Press button on top front of motor housing and lift
up and out.
Grasp lid and gently rotate one
quarter turn, counter-clockwise.
Lift up to remove.
Pull paddle up and out. For washing, hold upper
fitting (A) in place while rotating the lower fitting
(B) counter-clockwise. Reassemble fittings to
paddle prior to reassembly in unit.
Lift out inner bowl and inner bowl ring.
CAUTION: If the unit was just used, let
inner bowl come to room temperature
before removing.
Remove dispensing lever by first laying the housing on its back. Grasp the hub of
the lever, attached to housing, and turn away from you to release.
1 888
• •
C
557 3848
•
A
B
7