Troubleshooting - ReelSonar iBobber User Manual

TROUBLESHOOTING (1 OF 2)
Q-1: Trouble Syncing to iBobber?
A-1: First, the iBobber may simply be powered off. It automatically powers on
when it connects with water.
Note: When fully charged, the iBobber turns on when disconnected from the
charger and remains on for 25 minutes. This is for when you need need to
update firmware (page 25).
Cast the iBobber into the water you're fishing, or place it in any other water
(glass, sink, bathtub) and the iBobber sync should be visible in Settings >
Bluetooth Sync >.
A-2: The battery in the iBobber may be low. Recharge the iBobber in the
USB charger. Wait until the iBobber is charged and you can return to
syncing it with your device.
A-3: The iBobber may not sync with your mobile device or tablet because
of a Bluetooth issue with your device. Completely shut off and restart your
device. This will clear the Bluetooth cache and should allow iBobber to
connect. You may need to do this a few times. Does your device have
correct version of Bluetooth?
A-4: The iBobber may be too far from your mobile device (more than 100'),
waves might be periodically blocking the Bluetooth signal, or there may be
obstructions in the way of the signal. Try reducing the distance or remove the
obstructions and you should be able to sync.
23