Preventing Window Fogging; Heated Seats; Audio System Features - Chevrolet 2008 Cobalt User Manual

10
Getting to Know Your Cobalt
(Defog): This mode directs air to the
windshield, side window outlets and floor
outlets. Recirculation will not function in
this mode.
(Defrost): This mode directs most
of the air to the windshield and some air
to the side window outlets. Recirculation
will not function in this mode.
(Rear Window Defogger): Press
this button to activate the rear window
defogger. The defogger will shut off
automatically after about 20 minutes.
See Section 3 of your Owner Manual.

Preventing Window Fogging

To keep the vehicle glass fog-free, turn
the airflow control knob to the Defog
( ) mode or the Defrost (
Recirculation will not function in these
modes, allowing outside air into the
vehicle to help reduce moisture.
See Section 3 of your Owner Manual.
Heated Seats (if equipped)
There is one heated seat control button
for each front seat located on the
instrument panel center stack below
the audio system.
I
(Low): Press the switch to this
position to turn the system on low.
II
(High): Press the switch to this
position to turn the system on high.
Press the button again to the center
position to turn off the heated seat.
See Section 1 of your Owner Manual.
ENTERTAINMENT

Audio System Features

While most of the features on your radio
will look familiar, following are some that
may be new:
(Power/Volume): Press this knob to
turn the system on or off. Turn the knob
to adjust the volume.
) mode.
(Information): Press this button to
toggle the radio display between station
frequency and time. If equipped, it will
also display additional text information
related to the current FM-RDS or XM
station, or MP3 song.
(Tune): Turn this knob to select radio
stations or, when a CD is playing, to
select a track or MP3 file.
Press the knob to display the tone
control (bass/treble) or speaker control
(balance/fade) setting. Press the push-
button under the desired label on the
display. Turn the knob to adjust the
setting.
or the Tune knob, to adjust the speaker
control. Adjust the setting using the Tune
knob, SEEK, FWD or REV button.
BAND: Press this button to switch to
FM1, FM2, AM, or XM1 and XM2 (if
equipped). With a CD loaded or a
portable audio player connected, press
this button to switch to radio operation.
(Balance/Fade): Press this button,