Advertisement
2.
a. Slide the canopy onto the downrod.
b. Run the lead wires through the downrod.
c. Place the downrod onto the motor shaft by inserting clevis pin into the
aligned holes.
d. Insert cotter pin through the holes at the end of the clevis pin.
e. Tighten downrod to motor shaft with set screw.
NOTE: The rubber roller should be firmly sealed without metal-to-metal contact.
3.
a. Lift the fan motor up and place the plastic ball onto the bracket.
b. Make sure the guide pin of the bracket fits into the slot of the ball.
4.
a. Connect the fan wires according to wiring instructions.
b. Make sure the two earth wires (green wire) are connected to the supply
Earth wire properly
6
Advertisement
