Table of Contents
Advertisement
C. Studio Application
1
Connection with the Remote Control Unlt by the 26-pin
multi-cable
Connect the 26-pin studio cable between the camera
and the Remote Control Unit (RCU)
D. PC Mode System
Precaution: The specified software should be requlred for this operatlon. Please contact with qualifled service personnel for this
operatlon.
PC Mode System 1
Connect the WV-CA10B02, WV-CA10625 or WV-CA10B50 10/10-pin cable between the Remote Control Box Connector (37) on
this camera and Camera 1 Input Connector on the WJ-PC500
PC Mode System 2
Connect the WV-CA10B02, WV-CA10B25 or WV-CA10B50 10/10-pin conversion cable between the Camera 1 Input Connector on
this unit and the Remote Control Box Connector on the Remote Control Unit.
Connect the 25/9-pin converslon cable between the RS-232C/422 Connector on thls unlt and the computer
2 Connection with the Remote Control Unit by the coaxi-
al cable
Connect a coaxial cable between the Multiplex Signal
Connector (50) on the Camera Adaptor and the
Multiplex Connector (151) on the Remote Control Unit.
E. Gen-lock Studio Application
- Connect a coaxlal cable for the gen-lock signal between the black burst output on the productlon system and Gen-lock input
Connectors (143) or (203) on the RCU. (The signal may be bridged or looped through to another RCU.)
- Connect the coaxial cable for the lineview signal between the effect output connector on the production system and the
Auxiliary Input Connector (144) or (204) on the RCU. (The signal may be bridged or looped through to another RCU )
Notes:
1. The Tally light and Intercom between the camera, RCU and Speclal Effects Generator will function only when the 4-pin
cable for the Tally Iight and Intercom is connected between the RCU and Speclal Effects Generator.
2. The 26-pin studlo cable can be extended up to a maxlmum of approx 300m (1000 ft). When extending the cable, be
sure to Set the Cable Length Compensation Switch (115) to the position matching the extension lenght
3. The Subcarrier Phase Coarse and Fine Controls (139) and the Horizontal Phase Control (138) or (198) on the RCU should
be set to match other cameras in the system. Refer to page 54 for details. lo etalls.
4. Be sure to Set the Cable Selection Switches (73) on the Camera Adaptor and (152) or (201) on the Remote Control Unit to
MULTI positlon, if using the 26-pin multicores studio cable
- The MPX mode is avaliable when connecting the Camera Adaptor AW-AD700BSE
Notes:
1
When using the MPX mode by connecting the AW-AD700BSE, INCOM. AUX and R/G/B outputs are not functoned
2.
When the Colour Camera AW-F575E is connected to a desk-top type S-VHS VTR or directly to the video monitor for S-VHS
format, the S-VHS cable (S-vldeo cable) is required.
G/L OUT
- 43 -
Advertisement
Table of Contents
