Dcs; 1750Hz Tone Burst - Baofeng uv-82 Operating Manual

DCS

DCS settings are accessed from the menu with shortcuts 10 for R-DCS and 12 for T-DCS.
For a full list of available DCS codes and corresponding sub-tone frequencies, see the DCS Table in the Technical Specifications
section near the end of this manual.
Procedure: Setting up DCS
1. Press the [MENU] button to enter the menu.
2. Enter [1] [0] on the numeric keypad to get to Receiver DCS (R-DCS).
3. Press the [MENU] button to select.
4. Enter the desired DCS sub-tone frequency in hertz on the numeric keypad.
5. Press the [MENU] button to confirm and save.
6. Enter [1] [2] on the numeric keypad to get to Transmitter DCS (T-DCS).
7. Press the [MENU] button to select.
8. Enter the desired DCS sub-tone frequency in hertz on the numeric keypad.
9. Press the [MENU] button to confirm and save.
10. Press the [EXIT] button to exit the menu.
To turn DCS off, follow the same procedure but enter [0] for steps 4 and 8 instead of entering a sub-tone frequency.

1750Hz Tone Burst

To send out a 1750Hz tone burst, press the [PTT-A] or [PTT-B] button (or [BAND] button on some older models) while holding
down the PTT button.
This feature also works even when they keypad lock is enabled on the radio.
http://www.baofengradio.us
http://baofengradio.us
30