Installation - RestArt RK7101 User Manual

Installation

9
Installation 1
Step 1 Take out chair
Take out these pats from packaging box: chair body, cushion, pillow, left/right armrests,
remote control holder, cables, etc. It needs 2 people to take the chair body out. Hold the
metal frame(point out in below picture) and take the main body out from box slowly.
Refer to pictures
Main body
VFD control
Seat cushion
Right armrest up
Step 2 Set the main body
Raise the back to 120 degree until a click sound comes out.
'
Don t take this out
when you take out
the chair
Hold here to take out
Back cushion
Pillow
Manual control holder Cable
Left armrest up
Notice: In necessary maintenance,
lift the seat cover, pull the
lock catch upward, the back
of the chair could be foreraked.
Lay person is forbidden to do so.
Installation 2
Step 3 Install upper armrest L R /
1.Airtube connect: connect the black airtube to front air cock, the white to the back one.
2. Put the upper armrest at the middle of lower armrest, the front of upper armrest is
about 30mm out, push it backward, to make sure the retaining plates of upper and lower
armrests fixed. Fasten the upper armrests by M6*30 screws. 3. Fasten the zipper, and
fill the zipper in leather cover.
Reminding (dismantle upper armrests)
upper and lower armrests, pushing the upper armrests parallelly to make the locating
, ,
shaft out taking off the air pipes and then dismantle upper armrests
Front/behind air cocks Upper armrest Upper armrest fixing board
Lower armrest lower armrest
lower armrest
connecting tube
fixing board
Upper armrest
Zipper in leather cover
Installation
Open the zipper, removing the screws of fixing
.
Upper armrest screw hole
Push the upper armrest backward parallelly
30mm
lower armrest
screw hole
Zipper, uper armrest
Screw in the zipper
of uper armrest
10