Advertisement
5.
Route the connected USB Cable up to the glove compartment for storage and easy
access for programming.
Re-fit the kick panel to the vehicle
Figure 4 – Haltech Sport GM ECU with kick panel re-installed
6.
With the ECU installed do not attempt to start the vehicle.
You will need to configure the ECU.
The ECU is pre configured for use with a standard V8 engine.
If this is your setup then you will not have to load a base map. However, it
◦
is still strongly recommended that you check your settings before starting
your engine.
If a non standard engine or sensor combination is to be used then please
◦
go online with the ECU using the supplied ECU Manager software and
adjust any configuration settings affected according to your setup. If the
engine is modified, then all tables must be checked as the standard fuel
and ignition settings may not be appropriate to operate your engine safely.
With the correct settings configured in the ECU, the engine should be able to be started
at this point.
Advertisement
