Panasonic BB-HCM403A Getting Started page 3

Select the camera to set up and click [Execute].
• This program searches for the cameras that are connected to the router and
displays their MAC Addresses, IP addresses and Port Numbers.
. . .
MAC
Address Port
Camera
No.
Status
IP
Address
• The MAC Address (see page 9 of the Operating Instructions on the CD-ROM)
on the bottom of the camera shows which camera you select on the camera list
window.
Note
• If the indicator does not light green, check the connection (see page 1).
• If more than 20 minutes have passed since the camera was turned on, the
camera cannot be set up from the Setup Program. In this situation, turn the
camera off, and turn the camera on again.
• The Setup Program may not list any cameras due to your firewall or antivirus
software settings on your PC. If you cannot disable your firewall or antivirus
software, you can set up the camera by entering the camera MAC address on
the following window. The camera's MAC address can be found on the label
affixed to the bottom of each camera. See page 9 of the Operating Instructions
on the CD-ROM for details.
Click [Automatic Setup (Local Access Only)].
• To configure the network by Static or DHCP, click [Manual Setup].
See page 156 of the Operating Instructions on the CD-ROM for manual setup.
Enter the user name and password, and click [Save].
• The password must be different from the user name.
• Make a note of the user name and password for the reminder.
Security Warning window on Microsoft Windows XP Service Pack 2
To view a video (Motion JPEG) or to use audio feature, ActiveX Controls must be installed.
Follow the steps below to install ActiveX Controls.
Click the warning displayed above the tabs, and click [Install
ActiveX Control...].
Camera List window
Displays IPv4 or
IPv6 information.
The Enter Network Password window is displayed. Enter
the user name and password that were set, and click [OK].
When the Single Camera page is displayed, setup is
complete.
• If the Security Warning window is displayed when installing ActiveX
Controls, click [Yes].
• To install ActiveX Controls on Microsoft
2, see "Security Warning window on Microsoft Windows XP Service
Pack 2" below.
Note
• If the camera cannot be accessed, see page 9 of Troubleshooting on the CD-
ROM.
• To ensure that the most current image is displayed, Internet Explorer should
be configured as follows. This will not have a negative effect on normal use.
1. While viewing any website, click [Tools] → [Internet Options].
2. In the section "Temporary Internet Files", click [Settings] and check [Every
visit to the page].
To enable Internet access to the camera
Click [Next] to set up the Internet access to the camera and
go to page 4.
. . .
• If you do not allow Internet access, click [Cancel], and see page 15 of the
Operating Instructions on the CD-ROM.
Click [Install].
********
®
® ®
Windows XP Service Pack
3