Broadcast transmission to pre-programmed
parties!
This feature is useful for sending the same document often to selected parties whose fax
numbers are stored in the JOG DIAL directory. First program the parties (see below) then see
page 35 for transmission.
Before programming, make sure that the desired stations have been stored in the JOG
DIAL directory (p. 30).
Programming the stations in the broadcast memory
DIRECTORY PROGRAM
1
Press
Display:
DIRECTORY PROGRAM
2
Press
Press
.
3
SET
JOG DIAL
4
Rotate
is displayed.
Example:
5
Press
SET
.
Example:
To program other stations, repeat steps 4
and 5 (up to 20 stations).
Press
after programming all of the
6
SET
desired stations.
STOP
7
Press
.
USE JOG-DIAL OR
PRESS DIR.PROG.
again.
BROADCAST
PRESS SET
DIR=
[000]
until the desired name
John
[000]
DIR=John
[001]
REGISTERED
USE JOG-DIAL OR
PRESS DIR.PROG.
to exit the program.
Sending Faxes
Display
JOG DIAL
DIRECTORY PROGRAM
Note:
If you enter the wrong station, press
STOP
after step 5 to erase the station.
Confirm the stored numbers by printing a
broadcast programming list (p. 76).
STOP
SET
39