Intended Use; Safety Information; Disposal Information - Bosch BSG7....GB Instructions For Use Manual

Hide thumbs Also See for BSG7....GB:
Table of Contents

Advertisement

Please keep this instruction manual.
Please pass on this instruction manual if you pass this
vacuum cleaner on to a new owner.

Intended use

This vacuum cleaner is intended for domestic use and
not for commercial use.
This vacuum cleaner should only be used in accordance
with this instruction manual.
The manufacturer will not accept any responsibility for
damage caused by improper use or incorrect operation.
Therefore, please note the following points.
The vacuum cleaner must only be operated with:
Manufacturer's original dust bags
Manufacturer's replacement parts, accessories
and optional accessories
The vacuum cleaner is not to be used for:
Vacuuming persons or animals
Vacuuming up:
– insects or spiders
– hazardous, sharp-edged, hot or burning substances
– damp or liquid substances
– highly flammable or explosive substances and
gases
– Ash, soot from tiled stoves and central heating
systems

Safety information

This vacuum cleaner complies with the recognised
rules of technology and the relevant safety regulations.
We confirm compliance with the following European
directives: 89/336/EEC (amended by Directives
91/263/EEC, 92/31/EEC and 93/68/EEC). 73/23/EEC
(amended by Directive 93/68/EEC).
Always observe the information on the rating plate
when using the vacuum cleaner and connecting to
the power supply.
Never use the vacuum cleaner without a dust bag
fitted.
=> This can damage the vacuum cleaner.
Only allow children to use the vacuum cleaner under
strict supervision.
Keep the vacuum cleaner away from the face when
using tools and tubes.
=> Risk of injury.
Never carry the vacuum cleaner by the power
cord.
Fully extend the power cord when using the vacuum
cleaner continuously for several hours.
When disconnecting the appliance from the mains,
pull the plug, not the power cord.
Do not pull the power cord around sharp corners or
allow it to become trapped.
Unplug the vacuum cleaner from the mains before
carrying out any work on it.
Do not use the vacuum cleaner if it is damaged.
Unplug the power cord from the mains if a fault is
detected.
To prevent you from being exposed to risks, vacuum
cleaner repairs and the fitting of replacement parts
must only be carried out by the authorised after-
sales service.
The vacuum cleaner should be protected from
outside weather conditions, moisture and sources of
heat.
The vacuum cleaner is not suitable for use on
building sites.
=> Vacuuming up building rubble could damage the
vacuum cleaner.
Switch off the vacuum cleaner when it is not in use.
At the end of its life, the vacuum cleaner should be
disposed of in an appropriate manner.
For safety reasons, vacuum cleaners with a power
rating of more than 2,000 W are fitted with a
temperature safety switch.
This automatically switches off the vacuum cleaner if
it is blocked and overheating. Unplug the vacuum
cleaner from the mains and make sure that the
nozzles, suction pipe and hose are not blocked and
check whether the filter needs replacing.
Having cleared the blockage, leave the vacuum
cleaner to cool down for at least one hour. It can
then be switched back on again.

Disposal information

Packaging
The packaging is designed to protect the vacuum
cleaner from being damaged during transportation.
It is made of environment-friendly materials and can
be recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many recyclable
materials.
Therefore, please take used vacuum cleaners to your
retailer or recycling centre so that they can be
recycled.
For current disposal methods, please enquire at your
appliance dealership or local council.
!
Please note
Only connect the appliance to a socket that is
protected by at least a 16 amp fuse.
If a fuse should blow when you switch on the vacuum
cleaner, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from tripping, select the lowest
power setting before switching the vacuum cleaner
on, and increase the power only once it is running.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents