Panasonic KX-FLB882CX Operating Instructions Manual page 14

1. Introduction and Installation
2
Pull the output tray extender (1) forward gently until
it clicks into place, then press the centre part of the
extender (2) to open.
L Repeat from step 1 to install the upper output
tray.
1
2
Note:
L The upper output tray can hold up to approximately
100 sheets of printed paper. The lower output tray
can hold up to approximately 50 sheets of printed
paper.
Remove the printed paper before the output tray
becomes full.
If the top part of the extender is detached
1. With the top part of the extender in the open position,
insert the tab (1) into the left hole (2) of the
extender.
14
2
1
2. Slide the other tab (1) into the right hole (2) of the
extender from below until it clicks into place.
If the extender is detached
1. Line up the extender (1) underneath the output tray
(2), and insert the left side of the extender into the
output tray.
2. Attach the extender (1) by bending the side of the
output tray downward slightly and pressing the right
side of the extender.
2
1
1
2
1