Wall Surface Mounting - JBL Control CRV Owner's Manual

WALL SURFACE MOUNTING

CAUTION: Installation must be
done by qualifi ed persons using
safe rigging standards
The installer is responsible for proper selection
and use of mounting hardware, to properly and
safely wall-mount the speakers.
When deciding upon a location for the JBL Control CRV
speaker, take care NOT to install the mounting bracket closer
than 3" (7.6 cm) (horizontal) and 8-1/2" (21.5 cm) (vertical) to
the ceiling. Any closer than the minimum measurements will
not allow the clearance needed to position and slide the JBL
Control CRV speaker into the mounting bracket.
1. Run the wiring to the location desired for mounting the JBL
Control CRV speaker.
2. Using a level, secure the mounting bracket to the wall. Be
sure to use an appropriate anchor.
Corner/Wall-Mount-
Bracket Assembly
NOTE: There are two
cable access holes
provided in the Wall-
Mount Assembly.
3. Connect the stripped bare wires to the input terminals of the
JBL Control CRV speaker.
4. Set the tap selector switch to the desired 70V/100V tap, or to
the THRU position for 4 ohm low-impedance operation.
5. The mounting bracket is designed to trap the fl ange of the
JBL Control CRV speaker by securing the mounting-bracket
cap with two screws through the bottom of the mounting
.
3" Minimum distance
from ceiling
to top of bracket
8-1/2" Minimum distance
(horizontal mount)
from ceiling
to top of bracket
(vertical mount)
Appropriate
anchors
INSTALLATION
bracket. Rest the JBL Control CRV speaker's rear fl ange in the
mounting bracket, as shown. This will support the weight of the
speaker. Slide the mounting-bracket cap over the assembly.
Secure the mounting-bracket cap by inserting two #10-32 x 2"
screws (provided) in the bottom of the mounting bracket and
tightening.
Mounting-Bracket Cap
Mounting Bracket
6. To orient the JBL logo into the correct position, pull the JBL
logo slightly outward from the speaker grille and rotate. The
JBL logo is held in place by a spring. Peel the adhesive cover
off the mounting-bracket cover and attach to the top and bottom
of the mounting assembly.
Mounting-Bracket Cap
Mounting Bracket
(side view)
#10-32 x 2" Screws (2)
(side view)
Mounting Bracket
#10-32 x 2" Screws (2)
shown as looking through
the speaker.
Mounting-Bracket
Cover
Mounting-Bracket
Cover
3