CAUTION: Floorstanding
(tower) loudspeakers have a
high center of gravity and may
become unstable and tip over
during earthquakes, or if
rocked, tipped or improperly
WALL-MOUNTING
(Models L810, L820,
LC2)
Important Safety Notes
• Proper selection of mounting
hardware and installation of
the wall brackets are the
responsibility of the customer.
• This product is not intended
for ceiling mounting.
Two Number 8 round-head or
pan-head screws should be
used for each loudspeaker.
The screw head should be
between 5/16 inch (8mm) and
1/4 inch (6.3mm) in diameter,
and the screw should be at
least 2 inches (50mm) in
length.
When installing screws in any
wall, it is always preferable to
screw them into a wall stud. If
none is available, it is
important to always use
properly selected wall
anchors.
Attach two of the four self-
adhesive rubber pads that
came with the loudspeaker to
the back of the enclosure in
the two bottom corners so
that the cabinet is spaced
evenly from the wall. Select a
suitable mounting location on
a wall. (The ceiling is not a
suitable mounting location.)
Drill two pilot holes,
appropriately sized for the
specific self-tapping screw or
wall anchor that you will be
using. A template is included