Trantec S-D7200 Operating Instructions Manual

Digital wireless microphone

Advertisement

Quick Links

TRANTEC S-D7200
DIGITAl wIRElESS mICROPhONE

TABlE OF CONTENTS

1. SAFETY PRECAUTIONS ............................. 2
2. GENERAl DESCRIPTION ........................... 2
3. FEATURES ................................................... 2
4. hANDlING PRECAUTIONS ........................ 3
5. NOmENClATURE ........................................ 3
6. hOw TO INSERT BATTERIES .................... 4
7. DImENSIONAl DIAGRAm ........................... 4
8. OPERATION ................................................. 5
9. OPERATIONAl hINTS ................................ 5
Thank you for purchasing Trantec S-D7200 Digital Wireless Microphone.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
OPERATING INSTRUCTIONS
ID NUmBERS ............................................. 5
10.1. What Is ID ? ........................................ 5
10.2. Frequency Table ................................. 6
11. GAIN SElECTOR SwITCh ........................ 7
12. TEST mODE ON/OFF SwITCh ................. 7
13. TROUBlEShOOTING ................................ 7
14. SPECIFICATIONS ...................................... 8
Accessories ................................................. 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S-D7200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Trantec S-D7200

  • Page 1: Table Of Contents

    14. SPECIFICATIONS ........8 8. OPERATION ..........5 Accessories ..........8 9. OPERATIONAl hINTS ........ 5 Thank you for purchasing Trantec S-D7200 Digital Wireless Microphone. Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
  • Page 2: Safety Precautions

    • Make sure to observe the following handling precautions so that a fire or personal injury does not result from leakage or explosion of the battery. · Do not short, disassemble, heat nor put the battery into a fire. · Avoid using both new and old batteries together. · Do not solder a battery directly. · Be sure to use the specified type of batteries. · Note correct polarity (positive and negative orientation) when inserting a battery in the unit. · Avoid locations exposed to the direct sunlight, high temperature and high humidity when storing batteries. 2. GENERAl DESCRIPTION The S-D7200 is a UHF-band PLL synthesized wireless microphone capable of transmitting high-quality digital audio signals. A built-in dynamic type microphone unit features robustness and high-quality sound. 3. FEATURES • 32 kHz/24-bit high-quality digital audio signal processing frees wireless microphone from compander-induced sound quality degradation that may occur in analog systems. • Digital transmission and ID setting function enhance confidentiality of transmission information. Besides, they provide resistance to noise and radio interference, and stable transmission. • Optional receiver allows monitoring of the wireless microphone’s remaining battery level and setting data by means of digital transmission. • The maximum input sound pressure can be set in the range of 127 dB SPL to 142 dB SPL by the Gain selector switch, permitting adaptation to wide range of input sound pressure.
  • Page 3: Handling Precautions

    4. hANDlING PRECAUTIONS • Never open nor remove the unit case to modify the unit. Refer all servicing to your nearest TOA dealer. • Take care not to drop the unit onto the floor nor bump it against a hard object as the unit could fail. • Do not place the unit in locations of high temperature (ex. in an ill-ventilated car in summer) or high humidity as the unit could fail. • Avoid using the unit in locations that can be splashed with perspiration or seawater, as this could lead to unit failures. • To clean, use a dry cloth. When the unit gets very dirty, wipe lightly with a cloth damped in a dilute neutral cleanser, then wipe with a dry cloth. Never use benzine, thinner, or chemically-treated cleaning towel. • Avoid using a mobile telephone near the unit in use. Noise could be picked up. 5. NOmENClATURE Wind screen Lock ring (See p. 4.) Battery case Power indicator Internal antenna Lights green while power is on. Operation section POWER BATTERY Battery indicator Power switch...
  • Page 4: How To Insert Batteries

    6. hOw TO INSERT BATTERIES Note Minimize the volume of the mixer or amplifier connected to the receiver before opening or closing the case. Lock ring Step 1. Rotate the lock ring in the arrow direction shown at right, then pull the battery case down to open the battery compartment. Step 2. Turn off the power switch. Step 3.
  • Page 5: Operation

    8. OPERATION Step 1. Confirm that the wireless microphone and the wireless receiver are identical in group, channel, and ID numbers. Step 2. Turn on the Power switch. Then, confirm the battery indicator lights green or orange. Step 3. Turn off the power switch after use. 9. OPERATIONAl hINTS • When using two or more wireless microphones, keep them at least 50 cm away from each other to avoid malfunctions or noise. • Keep the wireless microphone at least 3 m away from the receiving antenna. Using the wireless microphone in close proximity to the antenna could result in malfunctions or noise. It is recommended that the wireless receiver’s built-in antenna attenuator be set for appropriate attenuation level when it is unavoidable to use the microphone closer to the antenna. Note: This distance differs depending on the installation location of the antenna and the length of the wired coaxial cable. 10.
  • Page 6: Frequency Table

    10.2. Frequency Table Group Channel 606.250 606.750 606.375 606.875 606.500 607.000 606.625 606.125 607.250 607.750 607.375 607.875 607.500 608.000 607.625 607.125 608.250 608.750 608.375 608.875 608.500 609.000 608.625 608.125 609.250 609.750 609.375 609.875 609.500 610.000 609.625 609.125 610.250 610.750 610.375 610.875 610.500 611.000...
  • Page 7: Gain Selector Switch

    11. GAIN SElECTOR SwITCh Gain can be changed in 6 steps (0, −3, −6, −9, −12, and −15 dB). The Gain selector switch sets the microphone sensitivity maximum at “0 GAIN dB” position and minimum at “−15 dB” position. −15 −3 If a loud voice distorts the output sound, decrease the sensitivity by setting the switch to the “−3 dB” position or less with the supplied screwdriver. −12 −6 −9 Note: The Input sensitivity setting switch is factory-preset to "0 dB." 12. TEST mODE ON/OFF SwITCh • Holding down the Test mode ON/OFF switch for 1 second or more with the supplied screwdriver causes the test signal to be transmitted. (This TEST condition is referred to as the Test mode.) Press this switch again to return to the usual condition. Note: Do not press the switch too strongly with a sharp-pointed object, as this may cause unit failure.
  • Page 8: Specifications

    50 Hz – 15 kHz Antenna Built-in type (Internal helical antenna) Modulation Type π/4 shift DQPSK Adjacent Channel Leakage Ratio 60 dB or more (±375 kHz separation) 45 dB or more (±250 kHz separation) Audio Latency 4 ms or less (when using in conjunction with the optional S-D7802) Audio Resolution 24 bits Coding System ADPCM (TRANTEC original) Dynamic Range (AF Circuit) Typ. 103 dB, A-weighted at THD=1 % Total Harmonic Distortion 0.05% or less (at 1 kHz/132 dB SPL input) Occupied Bandwidth 165 kHz or less ID Selectable 10 patterns Battery Two AA alkaline batteries Battery Life Approx. 5.5 hours (continuous use at 25ºC) Operating Temperature –10 to +50ºC (except batteries)
  • Page 9: Declaration Of Conformity

    7-2-1, Minatojima-nakamachi, Chuo-ku, Kobe, Japan 650-0046 declare, under our sole responsibility, that the product Product Name: DIGITAL WIRELESS MICROPHONE , DIGITAL WIRELESS TRANSMITTER DIGITAL WIRELESS RECEIVER Model Numbers: S-D7200-G8 Q , S-D7300-G8 Q , S-D7802-G8 GQ conform with following specifications 1,2,3) 1,2,3) ERM: : EN 300 422-2 V1.3.1 (2011-08),...
  • Page 10 COMPLIANCE STATEMENT TO S-D7200, S-D7300 URL: www.toa.eu...
  • Page 11 INTENDED USE OF S-D7200, S-D7300 URL: www.toa.de...
  • Page 12 Traceability Information for Europe Manufacturer: Authorized representative: TOA Corporation TOA Electronics Europe GmbH 7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo, Suederstrasse 282, 20537 Hamburg, Japan Germany URL: http://www.toa.jp/ 133-07-00003-00...

Table of Contents