Door Reversal - Danby DWC257BL Owner's Manual

1. Unplug the unit from the electrical outlet (if
connected) and lay it on its back.
2. Remove the screws from the Lower Hinge
Assembly.
3. Pull the door downward to remove it from the
cabinet of the Wine Cooler.
4. Remove the upper hinge pin from the top
right side of the cabinet and reinstall it on the
top left side.
5. Remove the plastic cap from the right side of
the door frame and reinstall it on the left side
of the door frame (the previous pin location).
D O O R R E V E R S A L
IMPORTANT!
REQUIRES: Phillips #2 Screwdriver.
Upper Hinge Pin
Ensure all screws and fittings are tightly fastened
and that the door is squarely aligned with the cab-
inet before using. Adjust if necessary.
6. Carefully reposition the door on the cabinet
and push up until the top hinge pin is
inserted into the top of the door.
7. While the door remains closed install the
lower hinge assembly.
8. Close the door and return the unit to its
upright position (wait 60 minutes before re-
connecting power to the Wine Cooler),
verify the door alignment and proper seal
against the cabinet.
N O T E
6
Lower Hinge Assembly
and Door Support Bracket