Using The Control Panel; Energy Saver - Samsung DA68-02787E User Manual

USING THE CONTROL PANEL

Freezer/Fridge (Temperature
adjustment)
Press the Freezer or Fridge button until the desired
temperature is set. For lower temperature, press
the Freezer or Fridge button until more LED lights
(coldest). For higher temperature, press the Freezer
or Fridge button until less LED lights (colder).
Each time you press the Freezer or Fridge button,
temperature indicator will change in below order.
Power Freeze
RF221 / RF220 / RL225
This icon will light up when you activate
the Power Freeze function. Power Freeze
function generates cool air for 50 hours
continuously and it makes the inside of
the refrigerator cool faster. This function is
useful when you make ice more quickly.
When you have enough, just press and hold
the Freeze (Hold 3 sec for Power Freeze)
button again for 3 seconds to cancel the
Power Freeze function.
RL220
This icon will light up when you activate
the Power Freeze function. Power Freeze
function generates cool air for 50 hours
continuously and it makes the inside of
the refrigerator cool faster. When you have
enough, just press the Power Freeze button
again to cancel the Power Freeze function.
When you use this function the energy
consumption of the refrigerator will
increase. Remember to turn it off when you
do not need it and return the freezer to your
original temperature setting.
If you need to freeze large amount of food
stuff, activate Power Freeze function at
least 24 hours before.

Energy Saver

This LED will light up when you activate the Energy
Saver function. The Energy Saver function is
automatically set to "ON" when power is supplied
to the Refrigerator. If condensation occurs on the
doors, turn the Energy Saver function off.
In some places, water drop may be
generated on the door part. In this case,
24_ operating
it is recommended to turn off the Energy
saver function.
Ice Off
This LED will light up when you activate the Ice Off
function. In this case, the ice will not be produced.
Alram On/Off
If the door alarm is set to On, an alarm beeps if any
refrigerator door is left open for more than three
minutes. The beeping stops when you close the
door. The door alarm function is pre-set to On in
the factory. You can turn it off by touching and then
releasing this button. You can turn it back on in the
same fashion. The LED lights up when the function
is on.
Reverse Osmosis Water Supply
IMPORTANT:
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 241
and 827 kPa.
If a reverse osmosis water fi ltration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 276 to 414 kPa. If the water
pressure to the reverse osmosis system is less
than 276 to 414 kPa:
• Check to see whether the sediment fi lter in the
reverse osmosis system is blocked. Replace
the fi lter if necessary.
• Allow the storage tank on the reverse osmosis
system to refi ll after heavy usage.
• If your refrigerator has a water fi lter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water fi lter.
If you have questions about your water pressure,
call a licensed, qualifi ed plumber.