Headphone Jack - JGC UR 210 USB User Manual

DISPLAY DIMMER
The brightness of the display is automatically adjusted for the room light conditions. It will be reduced
when the room lighting is turned off so as not to interfere with your sleep. The display will brighten
automatically in the daylight or when the room lights are turned on again for better visibility.
AUX INPUT
There is a 3.5mm stereo Aux input socket located at the back of the unit; analogue audio sound sig-
nals from other sources can be input to the radio through this socket.
When a 3.5mm jack is inserted to this input socket, the AUX IN function will be automatically selected.
The AUX-IN LED indicator on the front panel will be illuminated and the display will show the clock but
the function on the display will remain unchanged. The audio will be switched to the aux input signal
and you can adjust the volume control for your desired sound output level.
To resume back to normal Radio or USB operation, disconnect the jack from the input socket.
Note: The L/R audio input from other sources will be automatically combined to one single channel to
suit the single speaker design of this radio.

HEADPHONE JACK

The headphone jack is located on the right bottom front. Connect a set of headphones (not included)
to this jack for private listening. When headphones are in use, the speaker will be automatically cut
off.
Note: Only mono sound is available from the headphone jack, the stereo audio is converted to mono
and output to the L/R channel of the headphone inserted.
IMPORTANT: When using headphones always set the volume control to a low level before you put
the headphones on, then put the headphones on and gradually increase the volume to a comfortable
listening level.
OPERATION
18