Unpacking; Install The Platter; Install The Belt - Bryston BLP-1 Owner's Manual

return it for service, you must use the proper
packing material. Ship the unit only in the original
packing material, as the unit is not insurable by
carriers otherwise. Replacement packing materials
consisting of a shipping carton with plastic foam
inserts is available from Bryston for a small fee.

Unpacking

Both the BLP-1 turntable and the BTP-1 are
packed together. Minimal assembly is required.
1. Open the outer box at the top, remove the 4
foam corner spacers and set aside.
2. Lift the inner box out of the outer box
3. Open the inner box. Gently cut the tape, but do
not cut deep to prevent scratching materials
packed beneath.
4. Remove foam top sheet to reveal top pack
containing the following:
Clamp
Spindle
Aux Counter
Tip
5. Remove top pack containing parts to reveal the
remaining parts of the turntable preassembled.
4
Platter
Main Counter
Weight
Weight
Belt and
Wrenches
The BTP-1 Power Supply is boxed and packed
beneath the turntable in the bottom.
Assembly
Now that the BLP-1 and BTP-1 are unpacked,
select the final location of your turntable system
and prepare for assembly. This location should be
sturdy, immune from vibration, level, and away from
RFI/EMF radiating electronics.

Install the Platter

1. Unwrap the platter and remove shrink wrap
from the turntable plinth.
2. Place the platter upon the pre-installed spindle.
3. Screw the spindle tip into the spindle through
the platter. Gently tighten by hand. The cone
shaped profile of the tip perfectly centers the
platter upon the spindle.

Install the Belt

Wrap the belt around the motor pulley and the
platter.