Mercedes-Benz SLK-CLASS Operator's Manual page 21

Wind screen
Warning!
The wind screen can restrict the driver's
vision to the rear of the vehicle. To prevent
a possible accident when visibility is limited
(e.g. in darkness), the upper part of the wind
screen should be folded back.
1 Wind screen
2 Snap fastener (with handle cap)
3 Supporting strap
4 Fastening pin
5 Gap
G
6 Handle cap
Installing
Remove wind screen 1 from its stor-
age bag and unfold.
The storage bag is located on the wall
behind the seat backrests.
Attach supporting straps 3 to fasten-
ing pins 4.
Controls in detail
Retractable hardtop
i
Make sure the lower wind screen
edging is inserted through the gap 5
between the storage compartment and
the rear panel.
Close snap fasteners 2 by pushing in
handle cap 6.
Pull wind screen 1 on molding over
roll bars.
Pull the wind screen edging, not on the
netting itself.
Removing
Pull off wind screen 1 from roll bars.
Open snap fasteners 2 by pulling out
handle cap 6.
Loosen supporting straps 3 from fas-
tening pins 4.
Fold wind screen 1 and put it back
into storage bag.
259