ENSONIQ EPS-16 PLUS Musician's Manual page 99

EPS-16 PLUS Musician's Manual
Distortion Mix
Range: 00 to 99
Determines the wet/dry, or in this case, dirty/clean mix of the signal. A value of
00 gives a clean signal; 99 yields an all-distortion signal.
Reverb Decay Time
Low Freq Decay — Low Frequency Decay
Hi Freq Damping — High Frequency Damping
Hi Freq Bandwidth — High Frequency Bandwidth
Reverb Decay Rate/Amt
See the descriptions under HALL REVERB.
Early Reflection Lev
Chorus Rate/Amt
Chorus Mix
See the descriptions under CHORUS+REVERB.
WAH+DIST+REV
A final guitar+amp simulator, this time featuring distortion, compression, reverb,
and a resonant filter following the amplitude of the signal. Think of this as the
"Jerry Garcia" setting. Assign a sound to BUS1 for Wah distortion and reverb;
use BUS2 for reverb only. BUS3 is dry.
Bus1 Rev After Dist — Reverb After Distortion
Bus2 Reverb Mix
Reverb Decay Time
Hi Freq Damping — High Frequency Damping
See the descriptions under HALL REVERB.
Wah Filter Center
Range: 00 to 99
Determines where the resonant peak of the wah will occur. Higher values create a
higher pitched wah.
Wah Filter Range
Range: 00 to 99
Controls how much depth the wah will have. This is analogous to how far you
move a wah-wah pedal back and forth.
Compressor Threshld — Compressor Threshold
Dist Gain — (In and Out)
System Feedback
See the descriptions under CMP+DIST+REV.
Effect Parameters
Section 4 — Effects
4 - 17