3-9) Ice-Maker Function - Samsung RSE8KPAS Service Manual

Operating Instructions & Installation

3-9) Ice-Maker Function

The Ice-maker is referred to the device with an automatic ice production, storage in the ice bucket and dispensing
through the ice chute.
1) Preparation of Ice-maker
1-1) Connect the water line to the water supply valve of refrigerator to supply water. (See how to connect a water
supply line in the owner's manual.)
1-2) Push the bucket back fully so that the guide-ice of ice maker should not touch the back of bucket. (If the back of
bucket touches the guide-ice of ice maker, the ice maker will not make ice any more because of a ice full signal.)
1-3) It takes 6 hours to harvest a first ice, and throw away 2-3 times of these ice to make sure the supplied water clean.
2) Initial Operation function
2-1) Whenever the power is on, the control board checks the ice tray leveling with the leveling switch with in 2 seconds.
2-2) If the levelling switch is not in the off position, the geared motor will turn to the initial position to level the ice tray.
2-3) When the ice tray is leveled, it will remain this position for 2 hours (1 cycle time for ice production).
2-4) After 2 hours, the sensor located under the ice tray will measure the tray temperature. If the temperature is maintained
lower than -17℃ for 5 minutes, and the ice full switch is off position, the ice tray twisting process will begin.
- Horizontal Leveling upon Initial Power On
ON
Clockwise
Rotation(CW)
ON
Counter
Clockwise
Rotation(CCW)
ON
Ice Eject
S/W
Max Twist Point
Push the bucket back fully so that the
lever should not be pushed up.
2sec
880ms
(1)
Horizontal Position
18
200ms
1sec 1sec
850ms
1sec
Standby Standby
(2)
Horizontal Position
(3)
(Finish)