Chicago Electric MIG 180 Owner's Manual page 10

6a. Flux Core (Gasless) Wire Setup:
Remove the two Knobs securing the cables.
Connect the Black Ground Cable to the rear, red,
positive Terminal using the Knob.
Connect the Red Torch Cable to the front, black,
negative Terminal using the other Knob.
This is the initial setup, called
Direct Current Electrode Negative (DCEN).
6b. Solid Core (Gas Shielded) Wire Setup:
a. Remove the two Knobs securing the cables.
Connect the Black Ground Cable to the front,
black, negative Terminal using the Knob.
Connect the Red Torch Cable to the rear, red,
positive Terminal using the other Knob.
This is called Direct Current Electrode Positive
(DCEP).
b. Determine which type of shielding gas
would be appropriate for the welding
you will do - see chart on welder.
c. With assistance, set the cylinder
(not included) onto a shelf or cart near
the welder and secure the cylinder in
place with two straps (not included).
d. Remove the protective cap from the
cylinder (if present). Stand to the side of
the valve opening, and open the valve
briefly to blow dust and dirt from the valve
opening. Close the cylinder valve.
e. Obtain an appropriate Regulator/Flowmeter
(not included) and close its valve completely.
Thread its inlet connector onto the
cylinder and wrench tighten.
Note: If the threads do not match, then the Regulator/
Flowmeter is likely for a different type of cylinder/gas.
f. Attach the Gas Hose securely to the
outlet of the Regulator/Flowmeter
using a hose clamp (sold separately).
Page 10 For technical questions, please call 1-888-866-5797.
Flux Core (Gasless) Polarity Setup
DCEN
Knobs
–
+
Torch
(Red)
Ground
(Black)
Solid Core (Gas Shielded) Polarity Setup
DCEP
Knobs
–
+
Ground
(Black)
Torch
(Red)
c
f
e
–
Torch Polarity:
+
Ground Polarity:
+
Torch Polarity:
–
Ground Polarity:
Briefly open valve
d
to clean,
then close
valve.
Item 62181