Bar And Chain Combinations, Model 334T; Bar And Chain Combinations, Model 338Xpt; Saw Chain Filing And File Gauges - Husqvarna 334T Operator's Manual

Hide thumbs Also See for 334T:

Operator's manual (84 pages)

Workshop manual (54 pages)

Basic adjustment (4 pages)

Table of Contents

Available languages

Recommended original and replacement bar and chain combinations

Following is a list of recommended cutting equipment for the Husqvarna chain saw models 334T and 338XPT. The

combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and

vibration requirements of ANSI B175.1–2000.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the

corresponding maximum nose radius of a hard nose.

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which

will also achieve kickback reduction.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.

For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of

sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose

radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Low kickback saw chain is a chain which has only met the kickback performance requirements of ANSI B 175.1 safety

requirements for gasoline powered chain saws when tested on the representative sample of chain saws below 3.8 cu.

in. speciﬁed in ANSI 175.1. We recommend that you as a replacement use the listed chains or "Low kickback saw chains"

which are available at your dealer.