Table of Contents
Advertisement
Chapter 2 - Installation:
This chapter will explain how to install the iPAC-GM3 interface using the
GM3H and the GM3HXM harnesses. Some installations require you to
make wiring connections.
recommend removing the negative terminal from the vehicles battery prior
to
installation.If you do not feel comfortable making these connections, we
suggest you seek professional installation.
2.1a Harness GM3H: (No XM)
1. Carefully remove the radio from the dash of the vehicle.
2. Plug the 14 & 16-pin male ends of the GM3H harness into the 14 &
16-pin ports on the back of the radio. Next connect the factory 14 &
16-pin male connectors into the 14 & 16-pin female connectors on the
GM3H harness.
3. Optional Connections:
RED: Retains Accessory Power (RAP). Provides 12V(+) accessory power
after the vehicle is turned off up to 10 minutes, or until the drivers door
is open.
RED/WHITE: Non-functional wire; no connection is necessary.
Note: Insulate all wires that are on the IPAC-GM3 harness that are not
used for installation
4. Connect the 8-pin connector on the iPod docking cable to the IPAC-
GM3 interface. (DO NOT CONNECT IPOD AT THIS TIME, WAIT UNTIL
INITIALIZATION IS COMPLETE, SEE SECTION 2.2 FOR DETAILS)
5. Plug the male 24-pin connector of the GM3H harness into the
iPAC-GM3 interface.
iPod PLUG
& CABLE
To eliminate the risk of an electrical short, we
FACTORY 14 PIN HARNESS
iPod
FACTORY 16 PIN HARNESS
RCA CABLE
Red Wire From T-harness Optional
ACC +12V OUTPUT works with RAP
( Retained Accessory Power)
Male Plug
14 Pin Female Plug
16 Pin Female Plug
Male Plug
GM3H
Harness
iPAC-GM3
OPTIONAL
AUDIO
SOURCE
14 Pin Male Plug
FACTORY RADIO
16 Pin Male Plug
6
Advertisement
Table of Contents
