Advertisement
3b. If using a combustion engine: do NOT attempt to
adjust the throttle's failsafe position while the engine
is operating.
4. Move the controls for all channels to the desired
failsafe position.
SYSTEM AND RANGE CHECK
Check the instruction manual included with the Tactic radio for the proper steps to perform a system check before fl ight.
WARNING! Always make sure that power is applied to the transmitter BEFORE applying power to the
receiver and servos, and the Tx throttle stick is at minimum (idle) position. Failure to do so could result in the
model becoming uncontrollable and cause a safety hazard. It's best to check the system with the propeller
removed from the aircraft. Always perform a signal range check to ensure a good link exists between the transmitter
and receiver. Once fl ight is complete, immediately disconnect the power from the aircraft before removing power
from the transmitter.
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
CE COMPLIANCE INFORMATION FOR THE EUROPEAN UNION
Instructions for Disposal of Waste Equipment by Private Users in the European Union:
This symbol on the product or its packaging indicates this product must not be disposed of with other
household waste. Instead, it is the user's responsibility to dispose of their waste equipment by handing
it over to a designated collection point for the recycling of waste electrical and electronic equipment. The
separate collection and recycling of your waste equipment at the time of disposal will help to conserve
natural resources and ensure that it is recycled in a manner that protects human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city
offi ce, your household waste disposal service or location where you purchased the product.
Declaration of Conformity:
Product: Tactic TR826 2.4GHz Twin Antenna Receiver
Item number: TACL0826
The object of the declaration described here is in conformity with the requirements of the specifi cations listed below,
following the provisions of the European 2006/95/EC Low Voltage Directive:
EN 60950-1:2006+A11:2009+A1:2010+A12:2011
The object of the declaration described here is in conformity with the requirements of the specifi cations listed below,
following the provisions of the European R&TTE Directive 1995/5/EC:
EN 301 489-3 V1.4.1 (2002-08)
EN 301 489-1 V1.9.2 (2011-09)
EN 300 440-1 V1.6.1 (2010-08)
EN 300 440-2 V1.4.1 (2010-08)
5. Press and hold the receiver's "LINK" button. The Rx's
LED should blink twice. Release the LINK button,
and the LED should stay on continuously. The Tx
and Rx should now be linked, with the failsafe setting
for each channel set in the new position.
Advertisement
