PAC SWI-RC Installation Instructions Manual page 6

Appendix A. (Continued)
Step F.
Repeat Steps D and E, using the TEMP DOWN Button.
Step G.
If the vehicle is equipped with FAN UP and FAN DOWN buttons:
Repeat Steps D and E for these buttons as well.
Step H.
If the vehicle is NOT equipped with FAN UP and FAN DOWN buttons:
Step I.
Within 7 seconds, press and
hold for 5 seconds the button that
is to be learned on the steering
wheel.
Step J.
Release the button.
Step K.
If you need to program more buttons,
repeat steps I & J for each additional
audio function on the steering wheel.
Step L.
After all buttons are
programmed
Testing the SWI-RC
A. When testing the audio controls, the left LED on the
SWI-RC will flash indicating it is sending a command.
If any function does not work, repeat the programming
instructions (starting from Step 11) or refer to
Troubleshooting Guide.
B. (For Version #4 only) Test each Heater function of the
steering wheel controls. The TEMP and FAN should work
properly.
6
Press and release the programming/
mode button on the SWI-RC.
VOL
VOL
Program
remaining buttons
Once programming is
wait 7 seconds
completed,
The LED will flash three times
indicating end of programming.
The Interface will then flash
the version number it was
programmed for.
VOL
In either case, the
LED will flash once
and stay on.
The LED will turn off
during this process.
The LED will turn on
back on.
.
TEMP