• USB/RJ-45 LAN Cable • Quick Installation Guide Minimum System Requirements • 3G/4G USB MODEM with active subscription • 3G/4G USB MODEM is compatible with HN-MRN1U • iPhone 3G/3Gs or below • iPhone 30pin connector/USB Cable • PC with Ethernet Port and/or Wireless...
Hardware Description 4G Mobile Router & Access Point 2 3 4 5 6 Adjustable USB connector, when not in use, retracts into the WAN/LAN casing of the device, leaving a perfectly flush, rounded (RJ45 Converter Cable required) surface. DC Power Mini USB Slot Power Light Power Switch: •...
How to charge your HN-MRN1U? You should charge your HN-MRN1U when its battery Led is Red or no light.You can charge it via: • AC Adapter with USB port • USB Power Cable connected to your PC In both cases, make sure the adapter/power cable USB connector is plugged in DC Power Mini USB Slot.
• 3G/4G USB MODEM Led is active similar to same activity when plugged into PC , connected to Network and working. 8. To connect your PC to LogN HN-MRN1U, make sure your PC wireless is ON, search for “LogN_xxxx” in your PC wireless list, connect.
Page 6
11. Type “admin” for user name and “password” for password when prompted to type them. Changing Wireless Name 12. Select Wireless >> Basic 13. Here you will change the name of your Wireless Network. Type the Wireless Name (SSID) you want your Wireless Network appear with.
Page 7
Securing Wireless Connection 14. Select Wireless >> Security. 15. Select from “Security Mode” drop menu “WPA-PSK” . 16. Select “WPA Algorithms” as “AES” . 17. Type the Password for your Wireless Connection in “Pass Phrase” , Make it difficult for intruders to guess.
Page 8
• Signal Led is ON (not red: weak signal) • Network Mode Led is ON (not red: not registered) 7. To connect your PC to LogN HN-MRN1U, make sure your PC wireless is ON, search for “LogN_xxxx” in your PC wireless list, connect.
Page 9
• Battery Led is ON (not off: out of power or red: weak) • WiFi Led is ON (Stable/Blue) • Network Mode Led is ON (Stable/Blue) 6. To connect your PC to LogN HN-MRN1U, make sure your PC wireless is ON, search for “LogN” in your PC wireless list, connect.
Page 10
7. Make sure that your PC Operating System (ex. Windows) tells you are connected to LogN HN-APN2 wirelessly. 8. Connect to LogN HN-MRN1U page similar to what learnt in 3G/4G Hotspot Mode. 9. Select Internet >> WAN. 10. Open drop menu of “WAN Connection Type” and select “DHCP” , press “Apply”...
2. Slide the power switch of HN-MRN1U to “off” position. 3. Simply connect your Mobile Phone USB charging cable to the top USB port of HN-MRN1U. 4. Slide the power switch of HN-MRN1U to “C” position to start charging your Mobile Phone.