Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TBK TBK-2900D
Summary of Contents for TBK TBK-2900D
- Page 1 Dual CCD Box Camera Dual CCD Box Camera Instruction Manual TBK-2900D...
-
Page 2: Table Of Contents
CONTENTS Warnings & Caution ------------------------------------------------------------------------- 3 What’s in the Box? ----------------------------------------------------------------------------3 General Features ------------------------------------------------------------------------------4 Name of Each Part --------------------------------------------------------------------------- 5 Installation ---------------------------------------------------------------------------------------7 Connection-------------------------------------------------------------------------------------- 9 Specifications ---------------------------------------------------------------------------------10 OSD Menu Setting----------------------------------------------------------------------------11 Dimensions ----------------------------------------------------------------------------------- 19 Troubleshooting ----------------------------------------------------------------------------- 20... -
Page 3: Warnings & Caution
Never expose the camera to direct sunlight What’s in the Box? 1. Camera (TBK-2900D) Warning 2. C Mount Ring Never disassemble the unit by 3. IRIS Lens Jack unauthorized person. Serious and 4. Manual Permanent damage will occur. -
Page 4: General Features
GENERAL FEATURES Polarity Protection of Power Built-in Dual CCD Preventing damage to the power board Operating with two CCDs: Super HAD of Domes when the DC supply is CCD Color for daytime and B/W Ex-View connected to an inaccurate polarity CCD for nighttime. -
Page 5: Name Of Each Part
NAME OF EACH PART This Camera is equipped with CDS Sensor that makes Day & Night function executed accurately in the infrared area and both C and CS Mount Lens are adoptable. ① ② ③ ④ ⑤ FIG.1 1. CDS Sensor 2. - Page 6 NAME OF EACH PART ② ① ③ ④ FIG.２ ⑤ ⑥ ⑦ A. Name of Rear Part 1. Menu/Set Control Button 2. Video Output(CVBS) - 3. Power LED 4. Lux Control (10 steps) 5. UTP Video Output (UTP+/-) 6. GND 7.
-
Page 7: Installation
INSTALLATION Auto Iris Lens (Only DC LENS applicable) 1. Peel off the outer cover of Auto Iris Lens cable about 8mm from the end 2. Peel off the inner cover of Auto Iris Lens cable about 2mm from the end. 3. - Page 8 INSTALLATION AUTO IRIS Pin Formation 1.CONTROL- AUTO IRIS Connector (Camera body) 2.CONTROL+ 3.DRIVE+ 4.DRIVE- FIG.４ AUTO IRIS Lens Connector Fastening Bracket groove FIG.５ Set Bolt for Bracket is 1 / 4 - 20 UNC .
-
Page 9: Connection
L: 4.5mm ± 0.2mm (ISO Standard). CONNECTION CONNECTING TO MONITOR BY UTP CABLE 1. Connect the Video terminal division on the back of the camera with image input division of a Monitor. 2. You can use DC12V or AC24V in accordance with standardized power type. Please make sure if you use a right type of an adaptor and that you should connect the power after completed all installation. -
Page 10: Specifications
SPECIFICATIONS TBK-2900D Type BUILT-IN DUAL CCD Sony - 1/3” SUPER HAD Color CCD Image Device 1/3” B/W Ex-view CCD for night NTSC : 768 (H) x 494 (V) Effective Pixels PAL : 752 (H) x 582 (V) More than 600 TV Lines for B/W... -
Page 11: Osd Menu Setting
Storage Temp -20℃ ~ +60℃ DAY&NIGHT : 3~6Lux +/-10% Outside Menu Key (UP,DOWN,MENU/SET,LEFT,RIGHT) Control Day & Night change Lux control Dimension 64(W) x 61.5(H) x 133 (D)mm Weight 589g (1.3Lbs) Recommended Regulated DC 12V or AC24V with 500mA Power Supply Power supply OSD Menu Setting... - Page 12 OSD Menu Setting A. SETUP 1. You can open OSD Menu by operating Menu/Set Key and can change DC, VIDEO and MANUAL by operating to the left and right. 2. If to the left, Manual/Video mode will be set. If to the right, DC/Manual mode will be set. 3.
- Page 13 4. When SHUTTER Menu is set as MANUAL, you can open [Manual Shutter] and change it by operating Left/Right Key. OSD Menu Setting C. BLC 1. When BLC Mode is “ON” on OSD Menu, you can open BLC Menu by operating Menu/Set Key. 2.
- Page 14 E. WHITE BALANCE 1. You can select one among AWB, ATW, MANUAL and FIXED on [WHITE BAL] of OSD Menu by operating Left/Right Key. 2. When AWB Mode is “ON” on OSD Menu, you can open Manual Menu by operating Menu/Set Key and control RED, BLUE and White Balance Level.
- Page 15 G. FUNCTION 1. You can open Function Menu by operating Menu/Set Key on [FUNCTION] of OSD Menu. OSD Menu Setting H. CAMERA ID 1. When Camera ID is “ON” on Function Menu, you can open Camera ID Menu by operating Menu/Set Key.
- Page 16 I. MIRROR 1. You can change On/Off Mode by operating Left/Right Key. When it operates, the left and right side of the screen will switch position. J. DAY & NIGHT 1. You can select Auto/Color/BW mode on [DAY&NIGHT] of Function Menu by operating Left/Right Key.
- Page 17 4. To finish, press Menu/Set Key for about 1 second. 5. You can make ALL CLEAR/ ALL SET. Select [RETURN] to move to [Motion Area] menu and select [Exit] to move to [Motion] menu. OSD Menu Setting L. PRIVACY 1. You can move to [Privacy] Menu by operating Menu/Set Key on [FUNCTION] Menu. 2.
- Page 18 M. GAMMA 1. You can change Gamma Level from 0.05 to 1.0 on [Gamma] of Function Menu by operating Left/Right Key. 2. Initial setup is on ‘0.45’. N. LANGUAGE 1. You can change Display Language on [Language] of Function Menu by operating Left/Right Key. 2.
-
Page 19: Dimensions
DIMENSIONS... -
Page 20: Troubleshooting
TROUBLESHOOTING If you have trouble setting up or operating the camera, refer to the following. PROBLEM SOLUTION Check if the power is connected correctly. No picture Check if all the Cable is connected correctly. Check if you use DC Lens correctly for Video Lens Camera with heat, Abnormal motion Check if the power supply meets standard requirements and... - Page 21 Check if the Camera set toward Sun or fluorescent lamp. Blinking Screen Check if the connector of Auto Iris Lens is connected correctly when using. Check if the Lens gets dirty. You can wipe out with clean fabric or brush. Check if the monitor is in a condition as following;...
Need help?
Do you have a question about the TBK-2900D and is the answer not in the manual?
Questions and answers