Connect power
Caution
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the unit.
•
Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
•
Before you connect the AC power cord, ensure that
you have completed all other connections.
Demonstrate the features
In the standby mode, you can demonstrate
features by pressing .
» The features are displayed one by one
across the display panel.
•
To turn off the demonstration, press
again.
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Risk of decreased battery life! Never mix different
brands or types of batteries.
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
Downloaded From DvDPlayer-Manual.com Philips Manuals
100-240 V~50/60 Hz
AC MAINS~
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Set clock
1
In standby mode, press and hold CLOCK
on the remote control for more than two
seconds.
» [24H] or [12H] hour format is
displayed.
2
Press
/
to select [24H] or [12H]
hour format, and then press CLOCK.
» The hour digits are displayed and begin
to blink.
3
Press
/
to set hour, and then press
CLOCK.
» The minute digits are displayed and
begin to blink.
4
Repeat step 3 to set minute.
Note
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
You can view clock information in power-on mode by
pressing CLOCK.
Turn on
Press .
» The unit switches to the last selected
source.
EN
7