Operation; Storage; Engine Speed; Know Your Trimmer - Poulan Pro PR22WT Operator's Manual

11. Assemble new belt, idler pulleys and
bottom belt keeper to idler bracket.
Tighten pulley bolts securely.
NOTE: Be sure belt is inside top belt
keeper on idler assembly.
12. Position belt and idler assembly in
trimmer, reconnect idler spring and
assemble idler to chassis.
Engine pulley
Chassis
Control cable
Belt
Idler assembly
Top belt keeper
Bolt

ENGINE SPEED

Your engine speed has been factory set.
CARBURETOR
Your carburetor has a nonadjustable fixed
main jet for mixture control.
IMPORTANT: Never tamper with the
engine governor, which is factory set for
Immediately prepare your trimmer for stor-
age at the end of the season or if the unit
will not be used for 30 days or more.
TRIMMER
When trimmer is to be stored for a period
of time, clean it thor oughly, remove all
dirt, grease, leaves, etc. Store in a clean,
dry area.
13. Install belt around trimmer head pulley
and engine pulley.
NOTE: Be sure belt is inside belt keeper.
14. Replace debris shield and tighten the
four (4) screws securely.
15. Replace chassis cover and tighten
screw securely.
Idler bracket
Nut
Spacer
Spacer
V-idler
Idler
spring
Trimmer head pulley
proper engine speed. Over speed ing
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, take your unit to a qualified
service center, which has proper
equip ment and experience to make any
nec es sary adjustments.

STORAGE

1. Clean entire trimmer (See "CLEAN-
ING" in the Maintenance section of this
manual).
2. Lubricate as shown in the Main te-
nance section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fas tened.
moving parts for damage, breakage and
wear. Replace if necessary.
12

KNOW YOUR TRIMMER

READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR
TRIMMER. Compare the illustrations with your trimmer to familiarize yourself with the
location of various controls and adjustments. Save this manual for future reference.
These symbols may appear on your trimmer or in literature supplied with the product. Learn and
understand their meaning.
Flat idler
Bot tom
belt
keep er
Flat idler
Trimmer head
control lever
Throttle control
Starter handle
Handle knob
Gasoline cap
IMPORTANT: This trimmer is
shipped WITH OUT OIL OR
GASOLINE in the engine.
NOTE: Gasoline containing up to 10%
ethanol (E10) is acceptable for use in
this machine. The use of any gasoline
exceeding 10% ethanol (E10) will void the product warranty.
Trimmer head control bar – must be held
down to the handle to engage trimmer head.
Inspect
Release to stop the trimmer head.
Trimmer head control lever – used to
engage trimmer head.
Starter handle – used for start ing en gine.

OPERATION

Trimmer head control bar
Engine oil cap w/dipstick
Primer
Air filter
Primer – pumps additional fuel from the
carburetor to the cylinder for use when
starting a cold engine.
Throttle control – used for starting and
stopping the engine and allows you to
select either fast or slow engine speed.
5
Spark plug
Muffler
Chassis
cover
Trimmer
head
Trimmer
line