Yukon Trail solar wing 350 Owner's Manual page 3

1. To avoid damage to the battery when charging, use only the charger provided with
your Solar Go Cart. Go Kart should be off when charging.
2. Plug the supplied 24V battery charger into a 110V AC power source. Use only 110V AC
outlet when charging the Solar Go Kart battery.
3. The CHARGER INDICATOR LIGHT will illuminate confirming that power is connected.
4. Plug the POWER INPUT CORD to the charging port on your Solar Go Kart, located on
steering column.
5. When the battery is fully charged, Indicator Light will turn Green.
6. Disconnect the Input Cord from the Charging Port.
7. Disconnect the charger from the 110V power source.
8. Never leave the battery charger connected to the 110V power source when not
charging the battery. This will shorten the life of the charger.
9. When storing your Solar Go Kart, the battery should be charged monthly.
FAILURE TO KEEP THE SOLAR GO KART BATTERY CHARGED WILL CAUSE
TOTAL BATTERY FAILURE. DO NOT ALLOW BATTERY TO FULLY DISCHARGE.
When maintained properly, the Lead Acid Battery in this product has a normal life of
many years. When the battery expires, it should be removed from the Solar Go Cart
and recycled. Please contact your local solid waste authority for recycling information
in your area.
NOTICE: AFTER REMOVAL. COVER BATTERY TERMINALS WITH ELECTRICAL TAPE TO PRE-
VENT SPARK HAZARD FROM SHORTING OF THE TERMINALS.
CHARGING THE SOLAR GO KART BATTERY
Warning!
BATTERY DISPOSAL
GO KART SPECIFICATIONS
SPECIFICATIONS
Maximum Speed
Minimum Distance
Recharge Time
Load Capacity
Tires
Dimensions
Motor
Transmission
Battery
Ignition
10 MPH
18 Miles
8 Hours
150 lbs
9" Pneumatic
47.2 x 32.7 x 20.9in
350W
Chain Drive
12V 16Ahx2
On/Off Toggle Switch
3