Table of Contents
Advertisement
9.1 Replacement of fuse
Only an electric specialist or/and the manufacturer is permitted to execute that (in case of
replacement of fuse there will have to be a soldering).
See for those illustrations on page 30 / 3.
Replacing the fuse proceed as following:
. Unplug mains plug
2. Unscrew charging adapter from the wall
3. Remove back panel (7) by releasing the Torx screws *TX0* (8)
4. Pull out the electronic board ()
5. Check and replace fuse T 35 mA/230 V (2) and/or T 2 A/2 V/24 V (3)
6. Close in reverse order
Note:
a) Pay attention to the diodes () (2) push-ing in the board. Bent? g Adjust!
b) Put in back panel with the fixing hooks (0) into the openings (9) and then push back and
screw up the back panel.
Illustrations
30
Advertisement
Table of Contents
Need help?
Do you have a question about the SHL 100-Ex and is the answer not in the manual?
Questions and answers