Advertisement
Quick Links
Advertisement
Related Manuals for Xtracer XC Tracer V1.0
Summary of Contents for Xtracer XC Tracer V1.0
- Page 1 User Manual XC Tracer V1.0 User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 2 Once you’ve landed, turn off XC Tracer by pressing and holding the red button until you hear beep-beep (after approximately 3 seconds). XC Tracer will then switch off and the LED will stop blinking. User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 3 Turning XC Tracer off is just the same – press and hold the red button until you hear beep- beep. XC Tracer will write the log file to the SD card and switch off. User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 4 Low battery power XC Tracer’s low-voltage detection will switch the device off if the battery voltage drops below 3.3V. (NB. The log file is written to the SD card before the device turns off). User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 5 5Hz, meaning that position and altitude will be logged 5x per second. logFormat=KML With logFormat=KML you will record a KML file. With logFormat=IGC wou will log an IGC file, and with logFormat=None nothing will be recorded. logOnlyWhenFlying=yes User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 6 This can be helpful to find and core thermals in weak conditions. ClimbToneOffThreshold=0.1 User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 7 It‘s a good idea to only set sink rate and frequency for the sink alarm, and not set tone interval and duty cycle. This creates a nicer sink tone (not that a sink tone is ever nice!) User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 8 So, press the red button briefly to unmount / eject the device from your computer, disconnect it from the USB cable, then turn XC Tracer on as normal. Important: Always close the configuration file before you unmount / eject XC Tracer!!! User Manual XC Tracer V1.0 Rev 01 22.2.2016...
- Page 9 USB-MSD (Mass Storage Device) mode. XC Tracer’s internal Micro SD Card will appear as an external drive in Windows Explorer or the Mac Finder. Download the newest firmware for XC Tracer V1.0 from www.xctracer.com and copy the new firmware using drag and drop to the SD card.
- Page 10 State of the arte electronics including a 9-DOF IMU, GPS, BLE and mems pressure sensor Runtime with fully charged battery min. 14h Size: 57.5 x 57.5 x 19.25 mm Weight 61g User Manual XC Tracer V1.0 Rev 01 22.2.2016...