Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
TO ADJUST HANDLE (See Figs. 15 thru 17)
The handle can be mounted in a high or low position. The
mounting holes in the bottom of lower handle are off center
for raising or lowering the handle.
1. Remove upper handle and all wire tie(s) securing
cable(s) to lower handle.
2. Remove hairpin cotters from lower handle bracket
mounting pin.
3. Squeeze lower handle in to remove from mounting pins.
4. Turn lower handle over to raise or lower handle.
5. Squeeze lower handle in and po sition holes onto
mounting pins on handle bracket.
6. Reassemble upper handle and all parts removed from
lower handle.
TO ADJUST
LOWER HANDLE
MOUNTING PIN
HANDLE
BRACKET
MOWING
POSITION
HAIRPIN
COTTER
MOUNTING
PIN
LOW POSITION
SQUEEZE
HAIRPIN
COTTER
FIG. 15
MOWING
POSITION
HANDLE
BRACKET
HIGH POSITION
FIG. 16
ROTATE
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to
increase engine speed or it may result in personal injury. If
you believe that the engine is running too fast or too slow,
take your lawn mower to an authorized service center for
repair and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your lawn mower to an authorized service center for
repair and/or adjustment.
IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST AUTHORIZED SER VICE CEN TER,
WHICH HAS PROPER EQUIP MENT AND EXPERIENCE TO
MAKE ANY NEC ES SARY ADJUSTMENTS.
13
LOWER
HANDLE
FIG. 17
Hide quick links:
Advertisement
Table of Contents
