Related Manuals for XciteRC FLYBAR180 B Coax Bubble
Summary of Contents for XciteRC FLYBAR180 B Coax Bubble
- Page 1 Manual #12011000 XciteRC Flybar 180SB Coax Bubble IR pink #12012000 XciteRC Flybar 180SB Coax Bubble IR blue...
-
Page 2: Table Of Contents
Text and illustrations of this manual, no claims can be derived. NO LIABILITY FOR PRINTING ERROR! SUBJECT TO CHANGE! The latest version of this manual can be found on the Internet at www.XciteRC.de © Copyright 2013 by XciteRC-Modellbau GmbH & Co. KG... -
Page 3: Intended Usage
Introduction Thank you for purchasing the helicopter Flybar 180S from XciteRC. This manual contains important instruc- tions for operating your new model. Therefore, please read all instructions in this manual thoroughly before using the model, so that you can operate your model safely. -
Page 4: Safety Notes
WARNING: remove the drive battery from the model and transmitter after use. Store the model never with built-in battery. Fire hazard! • Store batteries separately on a non-combustible surface. • The drive components (motor and speed controller) or the car battery may become hot during operation. XciteRC Flybar 180S Coax... -
Page 5: Handling Precautions For Batteries Or Rechargeable Batteries
The XciteRC Modellbau GmbH & Co. KG cannot monitor the proper use of the battery or batteries you use, therefore, the warranty is excluded due to incorrect charging or discharging. -
Page 6: The Remote Control System
The remote control system Here you get an overview of the remote control system of your XciteRC Flybar 180S and its various features and settings. Before the fi rst fl ight, you should absolutely have read and understood all these functions and settings. -
Page 7: Battery Charging
• Check the motor and servo functions. • If the fl ight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a suitable place to land safely. Charge the fl ight battery again. XciteRC Flybar 180S Coax... -
Page 8: Rc Functions
NOTE: if the fl ight battery runs empty, the helicopter does not respond accurately to your com- mands, the fl ight is unstable. In this case land immediately. • Switch of the helicopter and then the transmitter. XciteRC Flybar 180S Coax... -
Page 9: Bubbles
Bubbles · Maintenance WARNING: the motor of the XciteRC FLYBAR 180S may get very hot during operation. Allow to cool down minimum 20 minutes before the next start to avoid damage. Fire hazard! Bubbles Fill the enclosed pipette with bubble fl uid. Place the thin tip into the fi lling hole of the tank (see fi gure) and fi ll the tank to the upper edge. -
Page 10: Troubleshooting
XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 7161 40 799 50 Email: service@xciterc.de Spare parts for the XciteRC FLYBAR 180S you may order in your local hobby shop or online at http://www. XciteRC.de/ Environmental Protection Notes The symbol of the crossed out dust bin on the product or packaging indicates that this product must be disposed of separately from normal household waste. - Page 11 Batteries also contain important raw materials such as iron, zinc, manganese or nickel and can be recycled. You can send us back the batteries after use either sufficient postage: XciteRC Modellbau GmbH & Co.KG Autenbachstr. 12 D-73035 Göppingen returned free of charge or in close proximity (eg in trade or municipal collection).
- Page 12 Sender IR Flybar 180SB Coax Rotor Head Repair Set USB Charging Wire round plug Transmitter IR Flybar 180SB Coax Set de pièces de réchange pour Emetteur IR Flybar 180SB Coax Cordon de charge USB fiche ronde tête de rotor XciteRC Flybar 180S Coax...
- Page 13 Konformität · Conformity · Conformité XciteRC Flybar 180S Coax...
- Page 14 XciteRC Flybar 180S Coax...
- Page 15 XciteRC Flybar 180S Coax...
- Page 16 XciteRC Modellbau GmbH & Co. KG Autenbachstraße 12 D-73035 Göppingen Phone: +49 7161 40 799 0 Fax: +49 7161 40 799 99 E-Mail: info@xciterc.de Web: www.XciteRC.de...