Start-Up/Shut-Down - YuLongDa H02 Installation Instruction

Loudspeaker wire (1 pin)

Connect with the external vehicle speaker, with a microphone, it can make 2
ways phone calls, or send voice alarms when theft behavior was detected;
 MIC wire (1 pin)
Connect with external microphone, used in voice monitoring case or phone calls;
2. After finished all wires connection, please connect with the power supply;
3. Hidden installation, please choose original main power wire, a fuse block (2A
protective tube) on the red wire end will protect the terminal from short circuit;
I. Terminal Operations

1. Start-up/Shut-down

Start-up: insert the SIM card, turn on back-up power supply, the terminal will start

up;
Shut-down: disconnect power plug, take out the SIM card, the terminal will shut

down;
2. Terminal parameters settings
All beginning letters in each parameters' commands shall use upper-case letters,
all punctuations shall be English punctuation, only part of commands will reply.
By sending enquiry commands to the terminal, corresponding contents will be
replied.
Commands shall be sent by the bound cellphone number.
 Cellphone SIM Card Number Binding
After the terminal start up normally, please bind your cellphone number first,
alarms will send to this bound number.
Send SMS: *ZC#terminal password# Cellphone SIM card number#Terminal
SIM card number#
Initial password is 000000, command start with *
e.g.: *ZC#000000#15888185569#12345678922#
 Password Modification
Send SMS: *MP#Previous terminal password#new terminal password# (6
numbers)
e.g.: *MP#000000#987654#
Initial password is 000000, new password is 987654
 Get Terminal Position by SMS
Send SMS: DW to terminal, it will reply the terminal current geography location
e.g.: south east 30 meters, ABC company, Meilong Rd, Shenzhen, Guangdong
Province,China.