Outdoor Camera - Perel SCAMSET User Manual

the dealer will not accept responsibility for any ensuing defects or problems.
•
Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
•
Mechanical wear and LEDs are not covered by warranty.
4. Features
•
camera with IR LEDs for night vision
•
two-way audio intercom
•
7" LCD colour display
•
door can be opened through the monitor with optional electrical door lock: HAA272
•
electrical door lock (12 V / 1 A): HAA272 (not incl.).
5. Overview
Refer to the illustrations on page 2 of this manual.
Image A - monitor
1 display
2 menu button
3
down button
4
up button
5 bell tone selector
6 mute button
Image B - Outdoor Camera
1 speaker
2 infrared led
3
camera
4
call button
5 microphone
6. Installation
6.1 Monitor
See image C on page 3.
Wiring diagram: see image E on page 4.
1.
Select a suitable installation location (depending on user height, location of the outdoor camera...).
2. Drill the holes using the bracket as a template.
3.
Attach the bracket using the included wall anchors and screws.
4. Connect the wires to the connectors on the back panel as shown on the wiring diagram.
5. Connect the power adapter to the back of the monitor.
6.
Attach the monitor to the bracket.
7. You also need to connect the cable from the monitor to the outdoor camera. If necessary, drill a
whole that will hold this cable.
Note: Intercom Volume
You can adjust the intercom volume if necessary. The potentiometer for the intercom volume is on the
back panel. To test the volume, you need to connect the monitor to the outdoor camera.
6.2

Outdoor Camera

See image D on page 3.
Wiring diagram: see image F on page 4.
1. Select a suitable installation position.
2.
Drill the holes using the camera bracket as a template.
V. 02 – 30/10/2013
SCAMSET
7 door unlock button
8 monitor/intercom button
9
microphone
10
mute indicator
11 intercom volume control
12 power in
6 ©Velleman nv